Car doors, locks and windows Peugeot 106

Door — removal, refitting and adjustment
Front door Removal 1. Open the door and, where applicable, disconnect the battery negative terminal (refer to " Disconnecting the battery "), before disconnecting the door wiring plug. Twist the locking collar to...

Door inner trim panels — removal and refitting
Front door - pre-July 1996 models Note: If the plastic sealing sheet is removed from the inside of the door, a new sealing sheet will be required on refitting. Removal 1. Where applicable, pull the window regulator...

Doorhandle and lock components — removal and refitting
Interior door handle Removal 1. Remove the door inner trim panel, as described in Section 12 . 2. Slide the handle assembly towards the rear of the door, then pull the assembly from the door aperture and disconnect the...

Door window glass and regulator — removal and refitting
Front door window glass Removal 1. Remove the door inner trim panel and the plastic sealing sheet, as described in Section 12 . 2. If not already done, remove the securing screws and remove the door pocket (where...

Tailgate and support struts — removal, refitting and adjustment
Tailgate Removal 1. Disconnect the battery negative terminal (refer to " Disconnecting the battery "). 2. Remove the two screws securing the tailgate trim panel, then release the securing clips and withdraw the panel...

Tailgate lock components — removal and refitting
Tailgate lock Removal 1. Open the tailgate, then remove the two securing screws and withdraw the lock from the tailgate, disengaging the lock lever as the lock is withdrawn (see illustration). 16.1. Removing the...

Central locking components — removal and refitting
Note: Before attempting work on any of the central locking system components, disconnect the battery negative terminal (refer to " Disconnecting the battery "). Reconnect the lead on completion of work. Electronic...

Electric window components — removal and refitting
Window switches 1. Refer to Chapter 12 . Window regulator motors 2. The regulator motors are integral with the regulator assemblies and cannot be obtained separately. 3. Removal and refitting details for the regulator...

Exterior mirror and associated components — removal and refitting
Mirror assembly Removal 1. On models with electric mirrors, disconnect the battery negative terminal (refer to " Disconnecting the battery "). 2. Prise the mirror trim plate from the inner edge of the door. Where...

Windscreen, tailgate and fixed windows — general information
These areas of glass are secured by the tight fit of the weatherstrip in the body aperture and are bonded in position with a special adhesive. Renewal of such fixed glass is a difficult, messy and time-consuming task,...

Opening rear quarter windows — removal and refitting
Removal 1. Open the window. 2. Support the glass, then working inside the vehicle, remove the screws securing the glass panel to the hinges and the handle. Withdraw the panel, taking care not to damage the surrounding...

Sunroof — general information
Two different types of sunroof may be fitted, depending on model. A simple tilt sunroof is fitted to some models, whilst a more complicated tilt/slide sunroof is fitted to higher-specification models. Removal of the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Body and interior: Doors, locks and windows Peugeot 206 (1998-2012)
➨ Body and interior: Doors, locks and windows Peugeot 307 (2001-2008)
➨ Body and interior: Doors, locks and windows Peugeot 405 (1987-1997)
➨ Body and interior: Doors, locks and windows Peugeot Partner I (1996-2008)

Link to this section in different formats

TEXTHTMLBB Code

Peugeot 106 (1991-2003)