Exterior (external body elements) Peugeot 106

Bodywork and fittings — specifications
Torque wrench settings Nm/lbf·ft Seat rail-to-floor securing bolts — 25/18 Seat belt mounting bolts — 20/15

General information
The bodyshell is made of pressed-steel sections and is available in both three- and five-door Hatchback versions. Most components are welded together, but some use is made of structural adhesives; the front wings are...

Maintenance — bodywork and underframe
The general condition of a vehicle's bodywork is the one thing that significantly affects its value. Maintenance is easy, but needs to be regular. Neglect, particularly after minor damage, can lead quickly to further...

Maintenance — upholstery and carpets
Mats and carpets should be brushed or vacuum-cleaned regularly, to keep them free of grit. If they are badly stained, remove them from the vehicle for scrubbing or sponging and make quite sure they are dry before...

Minor body damage — repair
Repairs of minor scratches in bodywork If the scratch is very superficial and does not penetrate to the metal of the bodywork, repair is very simple. Lightly rub the area of the scratch with a paintwork renovator, or a...

Major body damage — repair
Where serious damage has occurred, or large areas need renewal due to neglect, it means that complete new panels will need welding-in and this is best left to professionals. If the damage is due to impact, it will also...

Front bumper — removal and refitting
Removal Pre-July 1996 models 1. Disconnect the battery negative terminal (refer to " Disconnecting the battery "). 2. Remove both headlights as described in Chapter 12 . 3. Working in the engine compartment, unscrew the...

Rear bumper — removal and refitting
Removal 1. Disconnect the battery negative terminal (refer to " Disconnecting the battery "). 2. Open the tailgate. 3. Prise the plastic cover from the left-hand rear light unit (see illustration). 7.3. Prising the...

Bonnet and support struts — removal, refitting and adjustment
Bonnet Removal 1. Open the bonnet and have an assistant support it Using a pencil or felt tip pen, mark the outline of each bonnet hinge relative to the bonnet, to use as a guide on refitting. On later models, release...

Bonnet release cable — removal and refitting
Removal 1. Working in the engine compartment, unhook the end of the bonnet release cable from the lock lever. If necessary, unbolt the lock and move it to one side to facilitate this. 2. Where applicable, unscrew the...

Bonnet lock — removal and refitting
Removal 1. Open the bonnet. 2. Unscrew the two securing bolts and remove the lock assembly from the body panel (see illustration). 10.2. Bonnet lock securing bolts (arrowed) 3. Unhook the end of the bonnet release cable...

Body exterior fittings — removal and refitting
Wheel arch liners 1. The wheel arch liners are secured by a combination of self-tapping screws and push-fit clips. Removal is self-evident and normally the clips can be released by pulling the liner away from the wheel...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Body and interior: Exterior (external elements) Peugeot 207 (2006-2014)
➨ Body and interior: Exterior (external elements) Peugeot 305 (1977-1989)
➨ Body and interior: Exterior (external elements) Peugeot 406 (1995-2004)
➨ Body and interior: Exterior (external elements) Peugeot Partner I (1996-2008)

Link to this section in different formats

TEXTHTMLBB Code

Peugeot 106 (1991-2003)