Steering of the car Peugeot 106

Steering wheel — removal and refitting
Note: A new steering wheel securing nut must be used on refitting. Models without air bag Removal 1. Set the front wheels in the straight-ahead position and release the steering lock by inserting the ignition key. 2....

Ignition switch/ steering column lock — removal and refitting
Removal 1. Disconnect the battery negative terminal (refer to " Disconnecting the battery "). 2. Working under the steering column, remove the three steering column shroud securing screws. Unclip and lift off the upper...

Steering column — removal, inspection and refitting
Note: A new lower column pinch-bolt and nut must be used on refitting. Removal 1. Disconnect the battery negative terminal (refer to " Disconnecting the battery "). 2. Remove the steering wheel as described in Section...

Steering gear assembly — removal, overhaul and refitting
Note: New track-rod end balljoint nuts and a new lower steering column pinch-bolt and nut must be used on refitting. Manual steering gear Removal 1. Ensure that the steering lock is engaged. 2. Unclip the front edge of...

Steering gear rubber gaiter — renewal
1. On diesel models, to improve access, remove the inlet manifold as described in Chapter 4D . 2. Unscrew the securing bolts (while counterholding the nuts) and disconnect the inner ends of the track-rods from the...

Power steering hydraulic system — bleeding
1. This procedure will only be necessary when any part of the hydraulic system has been disconnected. 2. Referring to " Weekly checks ", remove the fluid reservoir filler cap and top-up with the specified fluid to the...

Power steering pump — removal and refitting
General 1. On early models without air conditioning, a belt-driven mechanical power steering pump is fitted, which is driven from the crankshaft via the auxiliary drivebelt (see chapter 1A or 1B ). 2. On early models...

Track-rod balljoint — removal and refitting
Inner balljoint Removal 1. Remove the track-rod as described in Section 18 . 2. Note the number of exposed threads on the balljoint shank, then loosen the locknut and unscrew the balljoint from the end of the track-rod....

Track-rod — removal and refitting
Note: A new track-rod outer end balljoint nut and a new track-rod-to-steering gear nut, must be used on refitting. Removal 1. Chock the rear wheels then jack up the front of the vehicle and support it on axle stands...

Wheel alignment and steering angles — general information
General 1. A car's steering and suspension geometry is defined in four basic settings - all angles are expressed in degrees (toe settings are also expressed as a measurement); the relevant settings are camber, castor,...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Chassis, running gear: Steering Peugeot 207 (2006-2014)
➨ Chassis, running gear: Steering Peugeot 305 (1977-1989)
➨ Chassis, running gear: Steering Peugeot 406 (1995-2004)
➨ Chassis, running gear: Steering Peugeot 605 (1989-2000)
➨ Chassis, running gear: Steering system Peugeot 807 (2002-2014)

Link to this section in different formats

TEXTHTMLBB Code

Peugeot 106 (1991-2003)