Electrical equipment and devices of the car Peugeot 106

Body electrical system — specifications
Bulbs — Wattage Headlight (H4 type bulb) — 60/55 Front sidelight — 5 Front driving/foglight (H3 or H1 type bulb) — 55 Front direction indicator light — 21 Direction indicator side repeater light — 5 Stop light/tail...

General information and precautions
Warning: Before carrying out any work on the electrical system, read through the precautions given in " Safety first! " at the beginning of this manual and in the relevant Part of Chapters. The electrical system is of...

Electrical fault-finding — general information
Note: Refer to the precautions given in " Safety first! " and in Section 1 of this Chapter before starting work. The following tests relate to testing of the main electrical circuits and should not be used to test...

Fuses and relays — general information
Fuses 1. Fuses are designed to break a circuit when a predetermined current is reached, in order to protect the components and wiring which could be damaged by excessive current flow. Any excessive current flow will be...

Switches — removal and refitting
Note: Disconnect the battery negative terminal before removing any switch and reconnect the terminal after refitting the switch. Refer to " Disconnecting the battery ". Ignition switch/steering column lock 1. Refer to...

Bulbs (exterior lights) — renewal
General 1. Whenever a bulb is renewed, note the following points: a) Disconnect the battery negative terminal before starting work. Refer to " Disconnecting the battery ". b) Remember that, if the light has just been in...

Bulbs (interior lights) — renewal
General 1. Refer to Section 5, paragraph 1 . Courtesy light 2. Carefully prise the light unit from its location in the roof console, then twist the bulbholder anti-clockwise and pull the bulb from the bulbholder (see...

Exterior light units — removal and refitting
Note: Disconnect the battery negative terminal before removing any light unit and reconnect the terminal after refitting the unit. Refer to " Disconnecting the battery ". Headlight - pre-July 1996 models Removal 1....

Headlight beam alignment — general information
Accurate adjustment of the headlight beam is only possible using optical beam-setting equipment and this work should therefore be carried out by a Peugeot dealer or suitably-equipped workshop. All models are equipped...

Instrument panel — removal and refitting
Removal 1. Disconnect the battery negative terminal (refer to " Disconnecting the battery "). 2.Unclip the front edge of the under-facia trim panel from the facia and lower the panel. Unscrew the two nuts securing the...

Instrument panel components — removal and refitting
General 1. Remove the instrument panel as described in Section 9 , then proceed as described under the relevant sub-heading. Speedometer 2. Working at the rear of the instrument panel, remove the three screws securing...

«Lights on» warning system — general information
Most vehicles covered by this manual are fitted with a "lights-on" warning system. The purpose of this system is to inform the driver that the lights have been left switched on, once the ignition switch has been turned...

Horn — removal and refitting
Removal 1. The horn is/are located at the lower lefthand or right-hand front corner of the engine compartment, depending on model. 2. Disconnect the battery negative terminal (refer to " Disconnecting the battery "). 3....

Speedometer drive cable — removal and refitting
Note: Some models do not have a cable-driven speedometer (see "Vehicle speed sensor" in Chapter 4B or 4C ). Right-hand drive models Removal 1. Remove the instrument panel as described in Section 9 . 2. Open the...

Wiper arms — removal and refitting
Removal 1. Operate the wiper motor, then switch it off so that the wiper arm return to the at-rest ("parked") position. 2. Stick a piece of tape along the edge of the wiper blade, to use as an alignment aid when...

Windscreen wiper motor and linkage — removal and refitting
Removal 1. Disconnect the battery negative terminal (refer to " Disconnecting the battery "). 2. On left-hand drive models, operate the wipers and switch off the ignition when the wiper arms are near the top of their...

Tailgate wiper motor — removal and refitting
Removal 1. Disconnect the battery negative terminal (refer to " Disconnecting the battery "). 2. Remove the tailgate wiper arm, as described in Section 15 . 3. Recover the spindle dust cover, then unscrew the trim disc...

Windscreen/tailgate washer system components — removal and refitting
Washer fluid reservoir Removal 1. Disconnect the battery negative terminal (refer to " Disconnecting the battery "). 2. Working in the engine compartment, unscrew the filler neck from the top of the reservoir (see...

Headlight washer system components — removal and refitting
Washer fluid reservoir 1. Proceed as described previously in Section 18 for the windscreen/tailgate washer fluid reservoir, but note that on early models, the headlight washer fluid reservoir is located on the left-hand...

Radio/cassette player — removal and refitting
Note: Once the battery has been disconnected, the radio/cassette unit cannot be re-activated until the appropriate security code has been entered. Do not remove the unit unless the appropriate code is known Removal 1....

Speakers — removal and refitting
Front door-mounted speakers 1. Disconnect the battery negative terminal (refer to " Disconnecting the battery "). 2. Remove the securing screws (prise out the trim plate for access to the top screw) and withdraw the...

Radio aerial — removal and refitting
Aerial mast 1. Note that the aerial mast can be unscrewed from the mounting on the roof and is available as a separate component. To remove the complete assembly, proceed as follows. 2. Carefully prise the courtesy...

Anti-theft alarm system and engine immobiliser — general information
Note: This information is applicable only to the anti-theft alarm system fitted by Peugeot as standard equipment. General Some models in the range are fitted with an anti-theft alarm system as standard equipment The...

Heated front seat components — general information
Certain models may be equipped with heated front seats. The seats are heated by electrical elements built into the seat cushions. For access to the heating elements, the seats must be dismantled; this work should be...

Air bag system — precautions and system de-activation
Pre-2001 models A driver's air bag is fitted as standard equipment on certain models and is an option on all other models. The air bag is fitted in the steering wheel centre pad. Additionally, a passenger's air bag...

Air bag system components — removal and refitting
Warning: Refer to the precautions given in Section 25 before attempting to carry out work on any of the air bag components. Caution: The following information is applicable to pre-2001 model year vehicles fitted with a...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Electrical equipment: Equipment and devices Peugeot 207 (2006-2014)
➨ Electrical equipment: Equipment and devices Peugeot 307 (2001-2008)
➨ Electrical equipment: Equipment and devices Peugeot 406 (1995-2004)
➨ Electrical equipment: Equipment and devices Peugeot Partner I (1996-2008)

Link to this section in different formats

TEXTHTMLBB Code

Peugeot 106 (1991-2003)