Weekly car checks Peugeot 106

Weekly checks — Introduction
There are some very simple checks which need only take a few minutes to carry out, but which could save you a lot of inconvenience and expense. These "Weekly checks" require no great skill or special tools, and the...

Underbonnet check points
Petrol model (1-1 litre shown) A. Engine oil level dipstick; B. Engine oil filler cap; C. Radiator filler cap; B. Brake fluid reservoir; E. Screen washer fluid reservoir; F. Battery Diesel model (1-4 litre shown) A....

Engine oil level
Before you start Make sure that your car is on level ground. Check the oil level before the car is driven, or at least 5 minutes after the engine has been switched off. The correct oil Modern engines place great demands...

Coolant level
Warning: DO NOT attempt to remove the expansion tank pressure cap when the engine is hot, as there is a very great risk of scalding. Do not leave open containers of coolant about, as it is poisonous. 1. The coolant...

Power steering fluid level
Before you start: Park the vehicle on level ground. Set the steering wheel straight-ahead. The engine should be turned off. 1. The power steering fluid reservoir is located on the left-hand side of the engine...

Brake fluid level
Warning: Brake fluid can harm your eyes an d damage pain ted surfaces, so use extreme caution when handling and pouring it. Do not use fluid that has been standing open for some time, as it absorbs moisture from the...

Battery care
Caution: Before carrying out any work on the vehicle battery, read the precautions given in " Safety first " at the start of this manual. Make sure that the battery tray is in good condition, and that the clamp is...

Electrical systems
Check all external lights and the horn. Refer to the appropriate Sections of Chapter 12 for details if any of the circuits are found to be inoperative. 1. If a single indicator light, brake light or headlight has...

Tyre condition and pressure
It is very important that tyres are in good condition, and at the correct pressure - having a tyre failure at any speed is highly dangerous. Tyre wear is influenced by driving style - harsh braking and acceleration, or...

Tyre tread wear patterns
Shoulder Wear Underinflation (wear on both sides) Under-inflation will cause overheating of the tyre, because the tyre will flex too much, and the tread will not sit correctly on the road surface. This will cause a loss...

Washer fluid level
Screenwash additives not only keep the winscreen clean during foul weather, they also prevent the washer system freezing in cold weather - which is when you are likely to need it most Don't top up using plain water as...

Wiper blades
Check the condition of the wiper blades; if they are cracked or show any signs of deterioration, or if the glass swept area is smeared, renew them. Wiper blades should be renewed annually. o remove a windscreen wiper...

MOT test checks
This is a guide to getting your vehicle through the MOT test. Obviously it will not be possible to examine the vehicle to the same standard as the professional MOT tester. However, working through the following checks...

Checks carried out from the driver's seat
Handbrake Test the operation of the handbrake. Excessive travel (too many clicks) indicates incorrect brake or cable adjustment. Check that the handbrake cannot be released by tapping the lever sideways. Check the...

Checks carried out with the vehicle on the ground
Vehicle identification Number plates must be in good condition, secure and legible, with letters and numbers correctly spaced - spacing at (A) should be at least twice that at (B). The VIN plate and/or homologation...

Checks carried out with the vehicle raised and the wheels free to turn
Jack up the front and rear of the vehicle, and securely support it on axle stands. Position the stands clear of the suspension assemblies. Ensure that the wheels are clear of the ground and that the steering can be...

Checks carried out on your vehicle's exhaust emission system
Petrol models The engine should be warmed up, and running well (ignition system in good order, air filter element clean, etc). Before testing, run the engine at around 2500 rpm for 20 seconds. Let the engine drop to...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ General information: Car care Peugeot 207 (2006-2014)
➨ General information: Weekly checks Peugeot Partner I (1996-2008)

Link to this section in different formats

TEXTHTMLBB Code

Peugeot 106 (1991-2003)