Automatic transmission of the car Peugeot 106

Automatic transmission — specifications
General Type — Automatic, 3 forward speeds and reverse Designation — MB3 Lubrication Recommended fluid — See " Lubricants and fluids " Torque wrench settings — Nm/lbf·ft Engine-to-transmission securing bolts — 35/26...

General information
Some models covered in this manual have an electronically controlled three-speed fully-automatic transmission, consisting of a torque converter, an epicyclic geartrain and electro-hydraulically-operated clutches and...

Selector cable — adjustment
1. Remove the air cleaner assembly as described in the relevant Part of Chapter 4 . 2. Move the selector lever in the car to the "1" (rearmost) position. 3. Using a large flat-bladed screwdriver, carefully lever the...

Selector lever and cable assembly — removal and refitting
Removal 1. Remove the air cleaner assembly as described in the relevant Part of Chapter 4 . 2. Move the selector lever in the car to the "1" (rearmost) position. 3. Using a large flat-bladed screwdriver, carefully lever...

Oil seals — renewal
Driveshaft oil seals 1. Refer to Chapter 7A . Torque converter oil seal 2. Remove the transmission from the car as described in Section 8 . 3. Remove the retaining strap then carefully slide the torque converter off the...

Heat exchanger — removal and refitting
Removal 1. The fluid cooler is mounted on the top of the transmission housing. To gain access to the fluid cooler, remove the air cleaner assembly and intake duct as described in the relevant Part of Chapter 4 and the...

Transmission electronic control components — removal and refitting
Note: Whenever a new ECU is fitted, the unit must be initialised using Peugeot diagnostic equipment before the transmission will function. If the following procedures are being undertaken with the intention of ECU...

Automatic transmission — removal and refitting
Removal 1. Chock the rear wheels, apply the handbrake and place the selector lever in the "I" (1st gear) position. Jack up the front of the vehicle and securely support it on axle stands (see " Jacking and vehicle...

Automatic transmission overhaul — general information
In the event of a fault occurring with the transmission, it is first necessary to determine whether it is of an electrical, mechanical or hydraulic nature and to do this, special test equipment is required. It is...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Transmission: Automatic gearbox Peugeot 206 (1998-2012)
➨ Transmission: Automatic gearbox Peugeot 307 (2001-2008)
➨ Transmission: Automatic gearbox Peugeot 405 (1987-1997)
➨ Transmission: Automatic gearbox Peugeot 605 (1989-2000)
➨ Transmission: Automatic gearbox Peugeot 807 (2002-2014)

Link to this section in different formats

TEXTHTMLBB Code

Peugeot 106 (1991-2003)