Lubrication system of car engine Peugeot 306

General information about the engine lubrication system
The engine has a forced lubrication circuit. A gear pump, driven from the crankshaft via a special chain drive, supplies oil under the required pressure to all bearings and all moving parts. The filling capacity is not...

Oil pump
3.1.1. Removal and installation Due to differences in operation, they are described separately for different types of engines. TU type engines The oil pump can be removed without removing the engine. Raise the front of...

Oil filter
The oil filter has a bypass valve and only filters with such a valve should be installed. To remove the oil filter, use a tie strap. Otherwise, you can place a piece of sandpaper on the filter, with the sandpaper facing...

Checking oil pressure
To check the oil pressure on a running engine, if you have the appropriate adapter, you can screw a pressure gauge into the hole under the oil pressure switch on the underside of the oil filter. In this case, proceed as...

Engine oil level
To check the engine oil level, the car is placed on a level surface. In addition, the oil must be warmed up to ensure that the oil is completely drained from the engine. To accurately measure the oil level, the oil in...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Power unit: Lubrication system Peugeot 207 (2006-2014)
➨ Gasoline engine: Lubrication system Peugeot J5 (1981-1993)

Link to this section in different formats

TEXTHTMLBB Code