Front drive shafts of car Peugeot 306

Front Drive Shafts — general description
Each of the front drive shafts on all Peugeot 306 models has on the gearbox side a so-called triaxial joint, which can move in the internal V-grooves, and a homokinetic constant velocity joint on the wheel side, which...

Removal the drive shaft
Since the seals on the gearbox side need to be replaced, a special rod is required to press the seals flush into the housing. To install the drive shafts into the seals, a protective sleeve is required, which is...

Installing the drive shaft
Thoroughly clean the areas where the drive shafts exit the gearbox, lubricate the sealing lips of the new oil seals and press the oil seals into the gearbox flush with the outer surface of the gearbox. Insert one of the...

Repair of drive shafts
Replacing rubber seals is the only work that can be done on drive shafts. Wear or damage to the shaft or joints requires the installation of a new complete shaft. The rubber seals should only be replaced using the...

Draining and filling fluid, removing air from the hydraulic system of the power steering
Turn off the engine. Disconnect the ground wire from the battery. Unscrew the union nut of the pressure pipe (1) in Figure 204 and pull the hose out of the fitting. Place a flat container under the steering mechanism....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Transmission: Drive shafts Peugeot 106 (1991-2003)
➨ Transmission: Drive shafts Peugeot 206 (1998-2012)
➨ Transmission: Drive shafts Peugeot 405 (1987-1997)
➨ Transmission: Drive shafts Peugeot J5 (1981-1993)

Link to this section in different formats

TEXTHTMLBB Code