The lubrication system of the DB9 engine of car Peugeot J5

Lubrication system — diesel engine d9b
The engine has a forced lubrication system. A gear pump, driven through a separate chain from the crankshaft, supplies oil at the required pressure to all bearings and all moving parts. The filling capacity of all...

Oil pump
17.1.1. Removal and installation The drive gear of a turbodiesel engine and a diesel engine of this type are not the same, this should be taken into account when replacing the oil pump. Removing the oil pump can be done...

Oil filter
The oil filter has a bypass valve and only filters with such a valve should be installed. The filter is located in the front of the engine compartment. To remove the oil filter, use a tie strap. Otherwise, you can place...

Checking oil pressure
To check the oil pressure on a running engine, if you have the appropriate adapter, you can screw a pressure gauge into the hole under the oil pressure switch on the underside of the oil filter (Figure 280). In this...

Engine oil level
To check the engine oil level, the car is placed on a level surface. In addition, the oil must be warmed up to ensure that the oil is completely drained from the engine. To accurately measure the oil level, the engine...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Power unit: Lubrication system Peugeot 207 (2006-2014)
➨ Diesel engine: Lubrication system Peugeot 306 (1993-2002)

Link to this section in different formats

TEXTHTMLBB Code

Partner I (1996-2008)