Axle specifications Lubricant (only for overhaul) Lubricant Type/Specification - Use only the specific lubricant supplied in sachets with boot kits. Otherwise, the hinges are pre-packed with grease and sealed Tightening torques for...
General information about drive shafts Torque is transmitted from the differential to the front wheels through two drive shafts (drive shafts), having different lengths. Each axle shaft ends on the outside with a splined section onto which the wheel hub is...
Drive axle axles — removal and installation Note. Do not put the car on wheels when one or both half shafts are removed, as this may damage the bearing (-ov) wheels (wheels). If vehicle movement is unavoidable, temporarily insert the outer end of the axle shaft...
Rubber boots of the axle shaft joints (PSA type axle shaft) — replacement External hinge 1. Remove the axle shaft as described in paragraph 2 . 2. Loosen the outer band of the rubber boot by cutting it with a hacksaw (pic. 4.2). Open the clamp and remove it from the cover. Pic. 4.2. Release...
Overhaul of the axle shaft — general information 1. If any of the checks described in paragraph «road test» in chapter 1A or 1B , shows signs of wear in one of the axle joints, perform the following procedures to determine the cause of the problem. 2. Fully apply the...
Intermediate support of the right axle shaft — replacement Note. To remove the bearing and bushing from the axle shaft, you will need an appropriate bearing puller. 1. Remove the right axle shaft as described in paragraph 2 . 2. Verify that the bearing outer race rotates...