Steering gear — removal All vehicles listed in this manual have rack and pinion steering. The steering is the same for all car models. The only exceptions are cars with a 2.1-liter diesel engine. The steering mechanism of these vehicles is...
Steering gear — installation and repair The steering mechanism is installed in the reverse order of removal. 13. Check up a condition of cuffs of the steering mechanism and be convinced that collars of their fastening have not weakened and have not displaced....
Steering neutral position The steering mechanism must be installed in the middle (neutral) position when checking or adjusting the angles of the wheels, as well as when removing and installing the mechanism. If the steering mechanism is...
Tie Rod Ends — Replacement The tie rod ends can be replaced without removing the steering gear. This is usually necessary when the tips are worn. However, we recommend removing the steering gear when replacing the tie rod ends. If the steering...
Wheel alignment 12.0 Distance A between the front wheels may be greater than the rear. In this case, the wheels have a negative convergence. With positive convergence, the value of the mentioned distances is opposite Workshops use...
Steering wheel — removal and installation Attention! If an airbag is installed on the steering wheel, all work must be carried out in compliance with the prescribed safety regulations. We recommend entrusting professionals with all work related to the removal...
Power steering — draining and filling fluid, bleeding Attention! The fluid level in the power steering reservoir should be checked regularly. 1. Stop the engine. 2. Disconnect the wire terminal «masses» (-) from the battery. 3. Place a container under the car to collect...