Doors, locks and windows of the car Peugeot Partner 1

Doors — removal and installation
Front door Removal 1. Disconnect the ground cable from the battery (see " Disconnecting the battery "). 2. Open the door, then release the locking ring and disconnect the door electrical connector. 3. Remove two bolts...

Interior Door Trim Panels — removal and installation
Front door Removal 1. On models without power windows, remove the window handle from the window lift shaft (figure 11.1). Figure 11.1. On models without electric windows, remove the handle 2. Using a small screwdriver,...

Front Door Handle and Lock Components — removal and installation
Interior door handle Removal 1. Remove the inner door trim panel as described in paragraph 11 . 2. Slide the handle assembly toward the front of the door to release the mounting tab, release it from the door and...

Sliding Door Handle and Lock Components — removal and installation
Note: To perform all of the steps below, the sliding side door must be removed from the vehicle ( see paragraph 10 ). Interior door handle Removal 1. Remove the inner door trim panel as described in paragraph 11 . 2....

Double-leaf rear door handle and lock components — removal and installation
External door handle Note: The outside handle is attached to the door with rivets. For installation, prepare new rivets of the appropriate size. Removal 1. Remove the inner door trim panel as described in paragraph 11 ....

Front door window glass and window regulator — removal and installation
Note: A new door waterproofing sheet may be required during installation. Window glass Removal 1. Remove the inner door trim panel as described in paragraph 11 . 2. Using a sharp knife, carefully separate the plastic...

Liftgate and support pillars — removal and installation
Lifting tailgate Note: New tailgate waterproofing sheets may be required during installation. Removal 1. Remove the tailgate trim panel as described in paragraph 28 . 2. Using a sharp knife, carefully separate the...

Liftgate Lock Components — removal and installation
Luggage compartment lift door lock Note: A new tailgate waterproofing sheet may be required during installation. Removal 1. Remove the tailgate trim panel as described in paragraph 28 . 2. Using a sharp knife, carefully...

Elements of the central locking system — removal and installation
Control unit 1. On early models, the central locking system is controlled by an electronic control unit located in the sill panel closer to the rear of the front door, on the driver's side. 2. On later models, the...

Windscreen, glass for the liftgate and glass for the rear double doors
These types of glass are attached by means of a tight seal fit in the body opening and are fixed in place with a special adhesive. Replacing fixed glass is a difficult, dirty and time-consuming job that is not...

Openable window glass — removal and installation
Side window glass Removal 1. Remove the three screws securing the window glass closing latch to the body (figure 21.1). Figure 21.1 Remove the three screws securing the door window glass closing latch to the body 2....

Sunroof — general information
The factory installed sunroof is a power tilt and slide sunroof. Due to the complexity of the hatch mechanism, significant experience is required to successfully repair, replace or adjust hatch components. Removing the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Body and interior: Doors, locks and windows Peugeot 106 (1991-2003)
➨ Body and interior: Doors, locks and windows Peugeot 206 (1998-2012)
➨ Body and interior: Doors, locks and windows Peugeot 307 (2001-2008)
➨ Body and interior: Doors, locks and windows Peugeot 406 (1995-2004)

Link to this section in different formats

TEXTHTMLBB Code

Partner I (1996-2008)