English Русский
Български
Беларускі
Український
Српски
Hrvatski
Română
Polski
Slovenský
Magyar
Bookmark Articles Sitemap Contacts
Company Hyundai Company Opel Company Skoda Company Kia Company Mitsubishi Company LADA Company Audi
PeugeotBook.ru
 
 
 
 
 
 
 
Series 100   Series 200   Series 300   400-500   Series 600   Crossovers   Others
 
Partner I (1996-2008) Peugeot 807 (2002-2014) Peugeot 806 (1994-2002) Peugeot J5 (1981-1993)

Brake system of the car Peugeot 806

  • Main
  • Пежо
  • Peugeot 806 (1994-2002)
  • Chassis, running gear
  • Brake system
The Peugeot 806's brake system is repaired according to specifications and includes a thorough inspection of each circuit. Front disc brake pad replacement and caliper repair require clean guides. The rear drums and disc brakes are inspected for wear, and the master cylinder and vacuum booster are tested by checking the pedal depth. After bleeding, the parking brake is adjusted and the ABS is checked.
Brake system specifications
Brake system specifications
Type − Dual-circuit brake system with diagonally arranged circuits and a brake force regulator. With or without ABS. With brake booster. The parking brake locks the rear wheels. The front wheel brakes are ventilated...
General description of the braking system
General description of the braking system
The rules for admitting vehicles to operation require the presence of two braking devices on passenger cars: a parking brake and a hydraulically operated foot brake. Both of these devices must operate independently of...
Front disc brakes — replacing brake pads
Front disc brakes — replacing brake pads
Caution: If the removed brake pads can be reinstalled, they must be marked accordingly to ensure they are installed in their original locations. In this case, it is also recommended to note which shoe is the inner shoe...
Front Disc Brake Caliper Repair
Front Disc Brake Caliper Repair
We do not recommend repairing the caliper. When the caliper wears out, it should be replaced with a new one. You can take the caliper to a specialized workshop that specializes in overhauling and repairing mechanisms...
Rear drum brakes
Rear drum brakes
Replacing brake pads On the rear side of the brake mechanism support shield there is an inspection hole, sealed with a plug. After removing the plug, you can shine a flashlight into the hole and visually check the...
Rear disc brakes — removal, installation, and replacement of brake pads
Rear disc brakes — removal, installation, and replacement of brake pads
Removal and installation of rear disc brake pads is performed in the same way as for the front wheels. The only difference is that in this case you need to unscrew both guide pins of the rear wheel brake caliper, and...
Brake Master Cylinder — removal, installation, and repair
Brake Master Cylinder — removal, installation, and repair
Removing and installing the master brake cylinder is a fairly simple operation and does not present any difficulties. The master brake cylinder is located on the end side of the brake booster. Before removing the master...
Vacuum booster brake drive
Vacuum booster brake drive
The brake booster cannot be repaired. Failure of the booster does not mean failure of the braking system. The efficiency of the system does not decrease, but to brake you need to press the brake pedal harder so that the...
Brake system — bleeding
Brake system — bleeding
Bleeding the hydraulic brake system is necessary after opening the system or after air has entered the system in any other way. Before bleeding the system, clean the bleed nipples and the expansion tank cap from dirt....
Parking brake adjustment
Parking brake adjustment
Drum brake mechanism The rear wheels should not turn when the parking brake lever is tightened to 4 or 5 notches. Repeat tightening the parking brake lever approximately four times. To check the wheel braking, the car...
Brake force regulator
Brake force regulator
The brake force regulator is attached to the rear axle using brackets to which it is screwed with nuts (see illustration 9.0). 9.0 Fastening the brake force regulator to the rear axle beam. 1 and 2 - regulator nuts When...
Vacuum pump
Vacuum pump
The vacuum pump is installed on vehicles with a diesel engine and is designed to provide low pressure to the brake booster, as well as other components operating at low pressure. The vacuum pump is attached to the...
ABS system
ABS system
The installed ABS system was developed by Bendix. The location of the ABS components on the vehicle is shown in Figure 11.0. 11.0 ABS System Components. The lines in the front of the vehicle are connected to the...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Share information:
See similar information for other Peugeot models

➨ Chassis, running gear: Brake system Peugeot 106 (1991-2003)
➨ Chassis, running gear: Brake system Peugeot 206 (1998-2012)
➨ Chassis, running gear: Brake system Peugeot 305 (1977-1989)
➨ Chassis, running gear: Brake system Peugeot 405 (1987-1997)
➨ Chassis, running gear: Brake system Peugeot 605 (1989-2000)
Link to this section in different formats
TEXTHTMLBB Code
Partner I (1996-2008) 
  • General information
  • Introduction to the guide
  • Faults en route
  • Weekly checks
  • User manual
  • Maintenance (petrol)
  • Maintenance (diesel)
  • Power unit
  • Petrol engines
  • Diesel engines «XUD»
  • Diesel engines «DW»
  • Overhaul of petrol engines
  • Overhaul of diesel engines
  • Cooling and heating
  • Power and exhaust (petrol)
  • Power and exhaust (XUD diesels)
  • Power and exhaust (DW diesels)
  • Emission reduction
  • Starting and charging system
  • Transmission
  • Clutch
  • Mechanical gearbox
  • Drive shafts
  • Chassis, running gear
  • Brake system
  • Car suspension
  • Steering
  • Body and interior
  • Exterior (external elements)
  • Interior (internal elements)
  • Doors, locks and windows
  • Electrical equipment
  • Equipment and devices
  • Electrical circuits
Peugeot 807 (2002-2014) 
  • General information
  • Operating instructions
  • Maintenance
  • Troubleshooting
  • Power unit
  • Gasoline engines
  • Diesel engines
  • Cooling and heating
  • Fuel injection (petrol)
  • Fuel system (diesel)
  • Fuel system
  • Exhaust system
  • Ignition system
  • Transmission
  • Clutch
  • Manual gearbox
  • Automatic gearbox
  • Chassis, running gear
  • Brake system
  • Car suspension
  • Steering system
  • Body and interior
  • Exterior (external elements)
  • Interior (internal elements)
  • Electrical equipment
  • Power devices
  • Electrical circuits
Peugeot 806 (1994-2002) 
  • General information
  • User manual
  • Maintenance
  • Power unit
  • Petrol engines
  • Diesel engines
  • Lubrication system
  • Cooling system
  • Fuel injection (petrol)
  • Fuel system (diesel)
  • Ignition and exhaust systems
  • ECM Bosch Motronic MP 3.2
  • ECM Magneti-Marelli (MM)
  • Transmission
  • Clutch
  • Mechanical gearbox
  • Chassis, running gear
  • Brake system
  • Car suspension
  • Steering
  • Electrical equipment
  • Equipment and devices
  • Electrical circuits
Peugeot J5 (1981-1993) 
  • General information
  • Introduction to manual
  • Specifications
  • Gasoline engine
  • Engine repair
  • Lubrication system
  • Cooling system
  • Fuel system
  • Ignition system
  • Diesel engine
  • Engine repair (DB9)
  • Lubrication system (DB9)
  • Cooling system (DB9)
  • Fuel injection (DB9)
  • Engine repair (U25)
  • Lubrication system (U25)
  • Cooling system (U25)
  • Fuel injection (U25)
  • Transmission
  • Clutch
  • Gearbox
  • Drive shafts
  • Chassis, running gear
  • Steering system
  • Car suspension
  • Brake system
  • Electrical equipment
  • Power devices
  • Electrical circuits
PeugeotBook.ru © 2018–2026 | Mobile version | Sitemap: EN BG BY UA RS HR RO PL SK HU | Write message | Site search | Add to bookmarks | Peugeot owners
106 (1991-2003) | 206 (1998-2012) | 207 (2006-2014) | 305 (1977-1989) | 306 (1993-2002) | 307 (2001-2008) | 405 (1987-1997) | 406 (1995-2004) | 605 (1989-2000) | Partner-I (1996-2008) | Eurovans-807 (2002-2014) | Eurovans-806 (1994-2002) | J5 (1981-1993) |
Cookies are used to ensure the correct display of pages on the site.