Car front and rear suspension Peugeot 806

Suspension specifications
Front suspension Type − Independent with shock absorbers, lower wishbones, coil springs and anti-roll bar. Suspension struts and shock absorbers are the defining elements of the suspension. The anti-roll bar is...

Front suspension
The front suspension consists of two MacPherson struts with a built-in shock absorber inside a coil spring. The lower part of the shock absorber is bolted to the steering knuckle. The lower wishbone is secured to the...

Shock absorber strut — removal, installation and overhaul
Removal Attention! The tilt position of the shock absorbers determines the camber angle of the wheels. For this reason, the upper shock absorber mounts cannot be swapped. There is a reference mark on the upper supports...

Front wheel hub and hub bearing — removal
The hub bearing is sealed, adjusted and lubricated to ensure its flawless operation throughout the entire life of the vehicle, without the need for maintenance or adjustment. The hub nuts are tightened to a specific...

Lower wishbone — removal and installation
The lower wishbone can be removed without removing the shock absorber strut. 1. Loosen the wheel nuts, then place the front of the vehicle on jack stands and remove the corresponding front wheel. The wheel suspension...

Rear suspension — removal and installation
The rear axle design is completely new. The rear axle is damped by separately installed coil springs and telescopic shock absorbers. The wheel suspension is carried out on longitudinal levers connected by a beam fixed...

Rear wheel hubs and hub bearings — removal and installation
The hub bearing is located in the hub itself. If the bearing is removed, it should be replaced with a new one, because it is built-in and cannot be installed after removal. This means that the bearing cannot be...

Drive shafts — removal
Drive shafts are different for all models and differ in length as well as diameter. Constant velocity joints also have their own specific features and are selected depending on the engine's power characteristics. The...

Drive shafts — installation
12. Clean the area around the drive shaft hole on the gearbox. 13. Lubricate the working surface of the new seal and drive the seal into the hole. The oil seal must be positioned so that its outer surface is flush with...

Drive shafts — repair
Replacing the CV joint protective boots is the only thing that can be done on your own regarding drive shafts. If the drive shaft or CV joint is worn or damaged, the shaft should be replaced with a new one as a set. New...

Drive shaft support bearing
When removing the right drive shaft, you can replace the support bearing on which this shaft is mounted. 1. Disconnect the support bearing housing mounting bracket from the cylinder block. If the thrust bearing did not...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Chassis, running gear: Car suspension Peugeot 106 (1991-2003)
➨ Chassis, running gear: Car suspension Peugeot 207 (2006-2014)
➨ Chassis, running gear: Car suspension Peugeot 305 (1977-1989)
➨ Chassis, running gear: Car suspension Peugeot 406 (1995-2004)
➨ Chassis, running gear: Car suspension Peugeot 605 (1989-2000)

Link to this section in different formats

TEXTHTMLBB Code

Partner I (1996-2008)