Front suspension — general information The front suspension is independent, with McPherson struts, lower wishbones and anti-roll bar. The rear suspension is independent, with transverse and trailing arms, telescopic shock absorbers and anti-roll bar. The...
Front suspension shock absorber — removal 1. Jack up the front of the vehicle and place it on jack stands. 2. Remove the corresponding front wheel. 3. Cars with ABS. Release the ABS sensor wire (wheel speed sensor) from the holder on the suspension strut. 4....
Front suspension shock absorber — disassembly 11. Disconnect the rack 1 of the anti-roll bar from the bracket on the suspension strut by unscrewing the nut (see illustration). 2.11 Disconnect the rack 1 of the anti-roll bar from the bracket on the suspension strut...
Swivel fist — removal and installation Attention! When dismantling the steering knuckle, it is recommended to fix the suspension strut spring with special holders (see illustration 3.1). 1. Fix the shock absorber spring with holders «A» as shown in the...
Front suspension wishbone — removal and installation 1. Fix the shock absorber spring with holders «2» as shown in the illustration. 4.1 Fix the suspension strut spring with holders «2» 2. Jack up the front of the vehicle, place it on jack stands and remove the...
Anti-roll bar front suspension — removal and installation 1. Fix the shock absorber spring with holders «A» as shown in the illustration. 5.1 Fix the suspension strut spring with holders «A» 2. Jack up the front of the vehicle, place it on jack stands and remove the front...
Rear wheel suspension — removal and installation The rear suspension is dampened by separately mounted coil springs and telescopic shock absorbers. The wheel suspension is made on trailing arms connected by a beam mounted on the body. 1. Jack up the rear of the...
The upper arm of the rear suspension — removal and installation 1. Jack up the rear of the vehicle, place it on jack stands and remove the rear wheels. 2. Compress the suspension coil springs by placing a suitable support under the lower arms (see illustration 6.4). 3. Remove both...
Lower wishbone rear suspension — removal 1. Jack up the rear of the vehicle, place it on jack stands and remove the rear wheels. 2. Compress the suspension spring using tool 0915-0 (see illustrations 6.4). 3. Disconnect the bar 5 of the anti-roll bar from both...
Lower wishbone rear suspension — installation Installation of the lower transverse arm of a back suspension bracket is made in sequence, return to removal. 9. Clean the threads of the lever mounting bolts, lubricate the bolts with a small amount of Molykote G Rapid...
Rear suspension shock absorber — removal and installation 1. Vehicles with suspension control unit. Disconnect plug 1 (see illustration). 9.1 Disconnect plug 1. Vehicles with suspension control unit 2. Jack up the rear wishbone (see arrow A in illustration 9.1), to relieve the...
Rear wheel hub — removal and installation Removing 1. Remove the brake disc (see relevant chapter) 2. Remove the protective cap 1 by prying it with a screwdriver, unscrew the nut 2 of the hub, remove the washer 3 (see illustration). 10.2 Remove protective cap 1...
Drive shafts — removal Torque from the gearbox to the drive wheels is transmitted using drive shafts, which, due to the shift of the gearbox to the left, have different lengths. Each drive shaft consists of internal and external joints of...
Drive Shafts — Installation Installation of drive shafts is carried out in the reverse order of removal, taking into account the following: 11. Inspect the drive shafts and CV joints. On the right drive shaft, check the condition of the support...