1. Jack up the rear of the vehicle and place it on jack stands.
2. Remove from pillows of a suspension bracket a back part of system of release OG.
3. Remove the fuel tank, see relevant chapter.
4. Support the rear axle beam with a suitable support to compress the coil springs. In specialized workshops, a special tool is used for this «A», leading its racks into technological recesses 1 on the lower levers and fixing the racks in these holes by turning a quarter of a turn (see illustration).
6.4 Install the special tool «A» under the rear axle beam by inserting its racks into technological recesses 1 on the lower arms
5. Disconnect the fuel filter 5 (depending on configuration), and then disconnect the two brake hoses 6 (see illustration).
6.5 Disconnect fuel filter 5 (depending on configuration), and then disconnect the two brake hoses 6
6. Disconnect the ends of both parking brake cables from the drive levers on the rear wheel brakes, and then release the cables from the holders on the cross member (see illustration).
6.6 Disconnect the ends of both parking brake cables from the drive levers on the rear wheel brakes, and then release the cables from the holders on the cross member
7. Release from the holders on the cross beam all wires, as well as hoses or pipelines that prevent the dismantling of the rear suspension, and also, if provided, disconnect the ABS sensors (see illustration).
6.7 Release from the holders on the cross member all wires, as well as hoses or pipelines that prevent the dismantling of the rear suspension
8. Install a garage jack or, if available, a special support under the rear suspension beam «A» (see illustration 6.0).
6. 0 Install a garage jack or, if available, a special support under the rear suspension beam «A»
9. Unscrew the bolts securing the trailing arms to the body, carefully lower the beam and remove it from under the car
Installation of a cross beam is carried out in sequence, return to removal.
Upon completion of work, bleed the brakes and adjust the parking brake.