9. Clean the threads of the lever mounting bolts, before screwing in, lubricate the bolts with a small amount of Molykote G Rapid Plus grease.
10. Install special mounting pins "a" (see illustration 8.4), catalog number 0532-B, to align the rear suspension cross beam.
11. Jack up the wishbone at point D (see arrow in illustration) so that the distance "a" between both holes for the upper arm mounting bolts is 425 mm. The tightening torque for the lower wishbone mounting bolts is 65 Nm.
8.11 Jack up the transverse arm at point D so that the distance "a" between both holes for the upper arm mounting bolts is 425 mm
12. Remove air from the brake hydraulic system.
You can find the original on the resource: PeugeotBook.ru