4.1 Secure the shock absorber spring with holders "2"
2. Jack up the front of the car, place it on jack stands and remove the corresponding front wheel
3. Unscrew the nut 1 of the ball joint pin of the transverse arm to the steering knuckle (see illustration).
4.3 Unscrew nut 1 of the ball joint pin of the transverse arm fastening to the steering knuckle
4. Press out the ball joint pin from the steering knuckle using a special puller "a" (see illustration 4.3).
(The source is located on the website: «PeugeotBook.ru»)
5. Secure the steering knuckle to the subframe with wire to prevent the drive shaft from becoming disconnected from the gearbox when removing the wishbone.
6. Unscrew bolts 2, which secure the rear part of the lower wishbone to the subframe (see illustration). Tightening torque of bolts 45 Nm.
4.6 Unscrew bolts 2, which secure the rear part of the lower wishbone to the subframe
7. Unscrew bolt 3 securing the front part of the transverse arm and remove the arm (see illustration 4.6). Bolt tightening torque: 110 Nm.
The front suspension wishbone is installed in the reverse order of removal.
8. Adjust the camber and toe-in of the front wheels.
Attention! It is recommended to entrust the adjustment of the camber and toe-in of the front wheels to a specialized workshop.