Table of contents: Steering knuckle 🠇 Front stabilizer bar 🠇 Adjusting the front wheel alignment 🠇 Tightening torques 🠇
Steering knuckle
Front stabilizer bar
[Source of the article is website PEUGEOTBOOK]
Geometry of front and rear axles
"A" is less than "B": positive toe-in (+).
"A" is greater than "B": negative toe-in (-).
Adjusting the front wheel alignment
Set the vehicle to a height of H1 above the ground (see description above).
If the obtained value does not correspond to the nominal value, it can be adjusted by rotating the racks (1) (one revolution is approximately 2 mm).
Tighten the nuts (2) to a torque of 55 Nm.
Tightening torques
 |
 |
 |
 |
 |
 |
 |
 |