Heating and air conditioning Peugeot 207

Technical data of heating and air conditioning system
Air conditioning system filling volume Peugeot cars can be equipped with automatic or manual air conditioning control systems. Refrigerant used: R134a. Note: When checking the charging, if the amount of refrigerant is...

Safety precautions when working with the air conditioning circuit
Coolant When working with refrigerant, wear protective glasses and gloves to avoid the risk of frostbite. Do not work with refrigerant near flames or very hot objects (for example, cigarettes), to eliminate the risk of...

Air conditioning system checks
Attention. The air conditioning system is monitored using a special tester "Clim Test 2" company "Valeo", connected to the station "EOSOSPsh". With the help of this same equipment, the air conditioning systems of...

Checking the air conditioning compressor
Caution: Before any work on the compressor, charge the air conditioning system to the required refrigerant level. If the system malfunction still occurs: Perform the checks described below. Preliminary check Visually...

Replacement of air conditioning system circuit elements
Air conditioner compressor Remove the air conditioning compressor (see below). Remove oil from the compressor and measure the amount of oil collected. Remove oil from new compressor (supplied, filled), to leave the same...

Air Conditioning Circuit Fault Diagnosis
Air Conditioning Circuit Fault Diagnosis Reference Chart Leaks Noise during operation Functional error Values of pressures measured in the air conditioning system circuit (the car does not move, the engine runs at low...

Oil change — filling (air conditioning compressor)
Note: The following are the operations that must be performed after removing the compressor. Remove the filler plug (1). Turn the compressor over and allow the oil to drain out. Install plugs at the compressor inlet and...

Tightening torques
Cooling circuit Air conditioner compressor Air Conditioner Expansion Tank

Removal and installation the dust filter
Removal Note: The dust filter is located in the engine compartment (on the right side). Please note: The filter element consists of two dust cartridges of different sizes. Remove the plastic housing (1). Tilt the lid...

Removal and installation the gear motor and cabin fan
Removal Disconnect the battery. Disconnect the retainer (1) and remove the right console side trim (2). Remove the glove box from the control panel (see section " Body "). Loosen the screws (4). Move aside the gear...

Removal and installation the fan control module
Removal Remove the trim (1), clips (2), and left console side trim (3). Cabin Fan Speed Controller Resistor (manual air conditioning) Disconnect the connector (4). Disconnect the interior fan speed controller resistor...

Removal and installation air conditioning system tubes and compressor
Removal Disconnect the battery. Drain the fluid from the engine cooling system. Remove: protective shield under the engine (depending on the model); front bumper (2) ( see the corresponding operation ); front right...

Removal and installation the heater fan
Removal Remove the fasteners (1) and cover (2). Loosen the screws (3) and remove the lower steering column cover (4) and the protective element (5), releasing it from the clips. Loosen the nuts (6) and remove the...

Removal and installation the temperature sensors for the air supplied to the passenger compartment
Removal Disconnect the battery. Remove the trim (1). Release the fasteners (2) and remove the left console side trim (3). Disconnect the fastener (5) and remove the right console side trim (4). Left side Turn the...

Removal and installation the heater radiator
Removal Disconnect the battery. Remove the trim (1). Release the fasteners (2) and remove the left console side trim (3). Relieve pressure in the cooling circuit. Install the clamps on the hoses (8). Remove the locking...

Removal and installation the capacitor
Removal Remove the front bumper (see section " Body "). Drain the liquid refrigerant from the air conditioning circuit. Disconnect the refrigerant lines from the condenser (see the corresponding operation). Remove the...

Removal and installation the pulley and clutch of the air conditioning compressor
Removal Special device: 1 - FACOM U35P puller. Disconnect the battery. Remove the air conditioning compressor. Place the air conditioning compressor in a vice in area "a". Caution: Install protection on the vice jaws....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Body and interior: Heating and air conditioning Peugeot 307 (2001-2008)

Link to this section in different formats

TEXTHTMLBB Code