Description and characteristics of automatic transmission On Peugeot 206 cars, depending on the version, an AL4 automatic transmission is installed. The gearbox has four forward gears and one reverse gear. The gearbox is computer controlled and has a lock-up system (torque...
Replacement of working fluid AT The AL4 automatic transmission does not require fluid replacement during its entire service life. You should only check the level of the working fluid every 60,000 km. Despite this, the gearbox has a system for...
Removal and installation of an automatic transmission The gearbox is removed upwards. The automatic transmission is sealed, so it is not necessary to drain the working fluid. Remove the gearbox in the following order: Pic. 6.103. Steering column offset: 1 - steering wheel;...
Removal and installation of the hydraulic block wiring harness Attention! This operation requires special attention. Be careful. Remove the wiring harness in the following order: remove the air filter assembly; Pic. 6.115. Removing the hydraulic unit wiring harness: 1 - pin...
Removal and installation of the vehicle speed sensor Note. Do not drain the transmission fluid. Removing the speed sensor - carry out in the following order: disconnect the wire from the negative terminal of the battery; put the car on a lift; disconnect the vehicle speed...
Removal and installation of the gearbox control mechanism Removing the gearbox control mechanism - carry out in the following order: remove the air filter assembly; Pic. 6.107. Disconnecting the control rod: 1 - bolt; 2 - clamp; 3 - ball bearing element remove element 3 of the...
Adjustment of the gearshift mechanism Adjust the gearshift mechanism in the following order: set the selector lever to the position «R»; Pic. 6.122. Adjustment of the gearshift mechanism: 1 - lever; 2 - black detail; 3 - orange detail move lever 1 (pic....