Car automatic transmission Peugeot 307

General information about automatic transmission
Some Peugeot 307 vehicles are equipped with adaptive automatic transmissions. Since the automatic transmission is a complex unit, its repair must be carried out exclusively at a Peugeot service station using special...

Automatic transmission specifications
Tables 5.7, 5.8, 5.9 show the main technical characteristics of the AL4 automatic transmission.

Oil aging counter
The AL4 adaptive automatic transmission requires no oil changes throughout its entire service life. The gearbox has an automatic oil quality detection system. The AL4 adaptive automatic transmission computer has an oil...

Precautions for operation and repair of automatic transmission
Towing Precautions Since the gearbox is lubricated only when the engine is running, towing the vehicle is permitted with the drive wheels raised. In exceptional cases, vehicles with automatic transmissions may be towed...

Automatic transmission diagnostics
For preliminary diagnostics of automatic transmission: take a test drive to warm up the gearbox; check the gearbox oil level; check the engine idle speed; check the accelerator cable for free movement and adjust if...

Replacing the AL4 automatic transmission
To remove the AL4 gearbox: turn off the ignition and disconnect the ground wire from the battery; Note: The automatic transmission is sealed, so it is not necessary to drain the oil when removing and installing it. the...

Replacing the gear selector mechanism
To remove the gear selector mechanism: turn off the ignition and disconnect the ground wire from the battery; remove the air filter housing; Figure 5.52. Ball joint location: 1 - ball tip; 2 - bolt; 3 - cable stop using...

Replacing the multifunction switch
To remove the multifunction switch: turn off the ignition and disconnect the ground wire from the battery; set the selector lever to the "N" position; remove the air filter housing; Figure 5.59. Elements of the gear...

Replacing the gear selector lever shaft sealing ring
To remove the gear selector lever shaft sealing ring, do the following: turn off the ignition and disconnect the ground wire from the battery; remove the air filter housing; Figure 5.59. Elements of the gear selection...

Replacing axle shaft sealing rings
To remove the drive shaft sealing rings: drain the oil from the gearbox; remove the drive shafts; Figure 5.61. Removing the left drive shaft sealing ring using puller 0338-C, remove the right axle shaft sealing ring...

Replacing the torque converter sealing ring
To remove the torque converter O-ring: remove the gearbox; Figure 5.62. Location of handles 0338-B (1) for removing and installing the torque converter (2) install handles 0338-B 1 (figure 5.62) for removing and...

Replacing the heat exchanger
To remove the heat exchanger: turn off the ignition and disconnect the ground wire from the battery; disconnect the electrical connector from the engine management computer; remove the air filter housing; remove the...

Checking the level and replacing the oil in the gearbox
To check the oil level: check for errors using a diagnostic tool; raise the car on a lift or place the car horizontally on an inspection pit; set the selector to position "P" without applying the parking brake; connect...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Transmission: Automatic gearbox Peugeot 106 (1991-2003)
➨ Transmission: Automatic gearbox Peugeot 206 (1998-2012)
➨ Transmission: Automatic gearbox Peugeot 405 (1987-1997)
➨ Transmission: Automatic gearbox Peugeot 605 (1989-2000)

Link to this section in different formats

TEXTHTMLBB Code