Share information:
Electrical equipment and devices of the car Peugeot 305
Electrical equipment specification
Battery Type - Lead-acid Voltage - 12 V Ground terminal - Negative Capacity: European countries - 45 A h Cold climate countries - 60 A h Generator Brand Paris-Rhone Sev-Marchal Type A12R12 71210602 Power 500 W 500 W...
Battery Type - Lead-acid Voltage - 12 V Ground terminal - Negative Capacity: European countries - 45 A h Cold climate countries - 60 A h Generator Brand Paris-Rhone Sev-Marchal Type A12R12 71210602 Power 500 W 500 W...
General description of electrical equipment
The vehicle's electrical system consists of three main components: (1) the battery, (2) the alternator with voltage regulator, and (3) the starter. The remaining electrical equipment can be divided into three main...
The vehicle's electrical system consists of three main components: (1) the battery, (2) the alternator with voltage regulator, and (3) the starter. The remaining electrical equipment can be divided into three main...
Fuses — location and purpose
1. The fuse box with a removable cover is located in the engine compartment on the inner surface of the left front fender (see photo). 2. The box has 7 fuse positions, numbered from front to back. The first position is...
1. The fuse box with a removable cover is located in the engine compartment on the inner surface of the left front fender (see photo). 2. The box has 7 fuse positions, numbered from front to back. The first position is...
Removal and installation the rear window wiper motor (Estate models)
1. Disconnect the negative cable from the battery. 2. Remove the windshield wiper arm and its shaft nut with washers. 3. Open the tailgate and remove the trim panel (be careful not to break the panel mounting clips). 4....
1. Disconnect the negative cable from the battery. 2. Remove the windshield wiper arm and its shaft nut with washers. 3. Open the tailgate and remove the trim panel (be careful not to break the panel mounting clips). 4....
Removal and installation the rear window washer nozzle (Estate models)
1. Carefully remove the nozzle, being careful not to damage the body coating. Remove the injector from the elbow connector (see photo) and secure the hose with something so that it doesn't fall back into the tailgate....
1. Carefully remove the nozzle, being careful not to damage the body coating. Remove the injector from the elbow connector (see photo) and secure the hose with something so that it doesn't fall back into the tailgate....
Instrument panel — removal and installation
1. Disconnect the ground cable from the battery. 2. To remove the instrument panel trim frame, lift it from below and bend it towards you (see photo). 3. Insert a small screwdriver between the top of the instrument...
1. Disconnect the ground cable from the battery. 2. To remove the instrument panel trim frame, lift it from below and bend it towards you (see photo). 3. Insert a small screwdriver between the top of the instrument...
Removal and installation of the instrument panel on models produced since 1983.
1. Disconnect the ground cable from the battery. 2. Remove the 4 screws securing the instrument panel trim. Remove the trim. 3. Remove the instrument panel from the two clamps holding its lower edge. Carefully pull the...
1. Disconnect the ground cable from the battery. 2. Remove the 4 screws securing the instrument panel trim. Remove the trim. 3. Remove the instrument panel from the two clamps holding its lower edge. Carefully pull the...
Low Oil Warning System (1985 Models) Description
1. The 1985 model is equipped with a low oil level warning system in the engine crankcase. The system consists of an oil level sensor located in the sump, a warning light on the instrument cluster, and an electronic...
1. The 1985 model is equipped with a low oil level warning system in the engine crankcase. The system consists of an oil level sensor located in the sump, a warning light on the instrument cluster, and an electronic...
Removal and installation the interior heater blower rheostat
Models before 1983. 1. Disconnect the ground cable from the battery. 2. Remove the handles from the heater control panel. 3. Remove the cigarette lighter and pull out the cigarette lighter housing, first turning it...
Models before 1983. 1. Disconnect the ground cable from the battery. 2. Remove the handles from the heater control panel. 3. Remove the cigarette lighter and pull out the cigarette lighter housing, first turning it...
Heater Blower Control Unit (1983 and later models) — description and testing
1. On the latest models, the rheostat does not transmit current to the blower motor. It simply sends a signal to a control unit consisting of a power transistor and a heat sink. The control unit is located on the inner...
1. On the latest models, the rheostat does not transmit current to the blower motor. It simply sends a signal to a control unit consisting of a power transistor and a heat sink. The control unit is located on the inner...
Central locking system — description
1. Since 1981, some models have been equipped with an electromagnetic central locking system, which sets the locks on all doors to the same position as the driver's door lock. The central lock does not exclude the...
1. Since 1981, some models have been equipped with an electromagnetic central locking system, which sets the locks on all doors to the same position as the driver's door lock. The central lock does not exclude the...
Electric windows — description
1. On some recent models, the front door windows are equipped with electric windows, driven by two electric motors controlled by two switches on the center console. 2. To gain access to the electric window mechanism,...
1. On some recent models, the front door windows are equipped with electric windows, driven by two electric motors controlled by two switches on the center console. 2. To gain access to the electric window mechanism,...
Windshield wiper blades — removal and installation
1. Windscreen wiper blades should be inspected regularly and replaced, especially if they begin to clean the glass poorly. Wipe the brushes with a damp cloth from time to time. 2. To replace the brush, lift the leash...
1. Windscreen wiper blades should be inspected regularly and replaced, especially if they begin to clean the glass poorly. Wipe the brushes with a damp cloth from time to time. 2. To replace the brush, lift the leash...
Windshield wiper arms — removal and installation
1. Before removing the wiper arm, turn the windshield wiper on and off to ensure that the arms are in the normal parked position (the brushes are parallel to the lower edge of the windshield). 2. Lift the flip cap on...
1. Before removing the wiper arm, turn the windshield wiper on and off to ensure that the arms are in the normal parked position (the brushes are parallel to the lower edge of the windshield). 2. Lift the flip cap on...
Windshield Wiper Mechanism — diagnosis and troubleshooting
1. If the windshield wiper does not work at all or works too slowly, check the motor connector for secure fastening and its wiring for damage and proper grounding. If everything is OK, check the current consumed by the...
1. If the windshield wiper does not work at all or works too slowly, check the motor connector for secure fastening and its wiring for damage and proper grounding. If everything is OK, check the current consumed by the...
Windshield wiper mechanism — removal and installation
1. Disconnect the ground wire from the battery and remove the windshield wiper arms ( see section 26 ). 2. Remove the 4 clips and the center Phillips head screw that secure the black plastic air intake grille in front...
1. Disconnect the ground wire from the battery and remove the windshield wiper arms ( see section 26 ). 2. Remove the 4 clips and the center Phillips head screw that secure the black plastic air intake grille in front...
Windshield Washer — general information
1. The washer system includes an electric pump that takes water from the washer reservoir and directs it to two nozzles that deliver water to the glass. To turn on the washer, with the ignition on, press the windshield...
1. The washer system includes an electric pump that takes water from the washer reservoir and directs it to two nozzles that deliver water to the glass. To turn on the washer, with the ignition on, press the windshield...
Sound signal — diagnostics and troubleshooting
1. The two horns are located behind the front bumper next to the right headlight and can be reached after removing the front grille. 2. If the horn does not work, disconnect the power supply wire (N 24) and use a 12V...
1. The two horns are located behind the front bumper next to the right headlight and can be reached after removing the front grille. 2. If the horn does not work, disconnect the power supply wire (N 24) and use a 12V...
Radios and car stereos — installation (general part)
A radio or car stereo will only work well if it is installed correctly. When purchasing them, you should check that they have the same polarity as the car's electrical system. The final choice of location for installing...
A radio or car stereo will only work well if it is installed correctly. When purchasing them, you should check that they have the same polarity as the car's electrical system. The final choice of location for installing...
Radios and car stereos — radio interference suppression (general part)
The main source of radio interference is a running generator. It produces a noise similar to that of an electric mixer, with the "mixer" working faster as the motor speed increases. To suppress generator interference,...
The main source of radio interference is a running generator. It produces a noise similar to that of an electric mixer, with the "mixer" working faster as the motor speed increases. To suppress generator interference,...
Radio interference from front brake calipers
1. On models prior to 1986, radio interference may occur from the front brake calipers (especially when driving on wet or salted roads). Interference passes to the radio receiver through the wires of the brake pad wear...
1. On models prior to 1986, radio interference may occur from the front brake calipers (especially when driving on wet or salted roads). Interference passes to the radio receiver through the wires of the brake pad wear...
Diagnostics of electrical equipment faults
The starter does not turn the engine The battery is dead The contacts on the battery terminals have become loose or corroded The starter electrical contacts are loose or corroded Open in solenoid wiring The...
The starter does not turn the engine The battery is dead The contacts on the battery terminals have become loose or corroded The starter electrical contacts are loose or corroded Open in solenoid wiring The...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
See similar information for other Peugeot models
➨ Electrical equipment: Equipment and devices Peugeot 106 (1991-2003)
➨ Electrical equipment: Equipment and devices Peugeot 207 (2006-2014)
➨ Electrical equipment: Equipment and devices Peugeot 406 (1995-2004)
➨ Electrical equipment: Equipment and devices Peugeot 806 (1994-2002)
Link to this section in different formats
TEXTHTMLBB Code
- User manual
- Keys, doors and alarm
- Controls and instruments
- Driving and operation
- Maintenance
- Power unit
- Petrol engines TU3 and TU5
- Petrol engines EW10
- Diesel engines DV10
- Diesel engines DW10
- Transmission
- Clutch and drive shafts
- Mechanical gearbox
- Automatic gearbox
- Chassis, running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heating and air conditioning
- Electrical equipment
- Equipment and devices
- Power devices
- Airbags
- Electrical circuits
- General information
- Introduction to manual
- Specifications
- Gasoline engine
- Engine repair
- Lubrication system
- Cooling system
- Fuel injection
- Ignition system
- Diesel engine
- Engine repair
- Lubrication system
- Cooling system
- Fuel injection
- Transmission
- Clutch
- Gearbox
- Drive shafts
- Chassis, running gear
- Steering system
- Front suspension
- Rear suspension
- Brake system
- Electrical equipment
- Power devices
- Electrical circuits
- General information
- Maintenance
- Power unit
- Gasoline engines
- Diesel engines
- Cooling system (gasoline)
- Cooling system (diesel)
- Fuel system (gasoline)
- Fuel system (diesel)
- Ignition system
- Transmission
- Clutch
- Mechanical gearbox BB8
- Mechanical gearbox BE1
- Automatic gearbox ZF4
- Shafts, hubs and wheels
- Chassis, running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Power devices
- Electrical circuits
- Wiring diagrams (diesel)

