Car front suspension Peugeot 307

General information and design of the front suspension
The suspension is the link between the body and the wheels. Through it, the forces acting on the wheels are transmitted to the body. The suspension serves to reduce dynamic loads, reduce body vibrations, soften the...

Front suspension specifications
Tables 6.1, 6.2, 6.3 show the main technical characteristics of the front suspension.

Replacing the shock absorber strut
To remove the shock absorber strut: loosen the front wheel mounting bolts, then raise the front of the car and secure it on stands; remove the front wheel; Figure 6.2. Location of shock absorber strut mounting nuts: 1 -...

Disassembly and assembly of the shock absorber strut
To disassemble the shock absorber strut: remove the shock absorber strut from the car; Figure 6.5. Compressing the shock absorber spring using the MG INTERNATIONAL tool (1) secure the front suspension shock absorber...

Replacing the steering knuckle
To remove the steering knuckle: raise the front of the car and secure it on stands; remove the front wheels; Figure 6.7. Fastening the device that prevents the hub from turning: 1 - cotter pin; 2 - cap; 3 - nut, 325 Nm;...

Replacing the front wheel hub bearing
To remove the front wheel hub bearing: remove the steering knuckle; Figure 6.10. Removing the retaining ring (1) holding the front wheel hub bearing remove retaining ring 1 (figure 6.10), front wheel hub bearing...

Replacing the steering knuckle ball joint
To remove the steering knuckle ball joint: remove the steering knuckle; secure the steering knuckle in a vice; Figure 6.20. Location of the protective plate (1) on the ball joint housing remove the protective plate 1...

Replacing the lower control arm
To remove the lower control arm: raise the front of the car and secure it on stands; remove the front wheels; Figure 6.2. Location of shock absorber strut mounting nuts: 1 - nut for fastening to the anti-roll bar link;...

Replacing the front anti-roll bar
To remove the front anti-roll bar: lift and secure the car, leaving the front wheels off the ground; Figure 6.23. Front anti-roll bar mounting: 1 - nut, 36 Nm; 2 - nut, 104 Nm; 3 - clamp unscrew nuts 1 (figure 6.23) tie...

Car suspension adjustment — general information
Checking the installation angles of the front and rear wheels, as well as adjusting the installation angles of the front wheels and tightening the bolts and nuts securing the hinge elements of the front and rear...

Adjusting the front suspension of a car
To adjust the front suspension of the car: Figure 6.42. Adjusting the front suspension of the car: 1 - belt; 2 - rings; 3 - screw mechanism for compressing springs; 4 - crossbar hook straps 1 with rings 4 (figure 6.42)...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Chassis, running gear: Front suspension Peugeot 206 (1998-2012)
➨ Chassis, running gear: Front suspension Peugeot 405 (1987-1997)

Link to this section in different formats

TEXTHTMLBB Code