Exterior (external body elements) Peugeot 305

General description of the body
The Peugeot 305 has a welded "monocoque" body (with working skin), built using a large number of prefabricated parts. This design is a direct result of tests carried out by the company. The interior has a rigid,...

Hinges, Door Latches, and Locks Maintenance
1. Periodically lubricate the hinges of the hood, trunk lid and doors with light oil. It is recommended to do this after washing the car, especially if detergents were used. 2. Simultaneously lubricate the hood lock...

Hood cover — removal and installation
1. Open the hood all the way. 2. Mark the position of its hinges so that you can later install them in their original place. Ask an assistant to hold the hood and remove the upper hinge bolt and the nut securing the...

Doors — removal and installation
1. Both front and rear doors are removed in the same way. Open the door you want to remove and prop it up from below (without raising). 2. The axes of the upper and lower hinges have plastic caps at the ends. After...

Door glass — removal and installation
1. The procedure for removing and installing glass is almost the same for both front and rear doors. Here we provide the procedure for removing and installing the front left door glass. 2. Remove the inner door trim (...

Door Lock Cylinder — removal and installation
1. The front door lock cylinder is secured in place with a sliding clip (see photo). 2. Remove the door trim ( see section 9 ) and lift the glass all the way up to open the sliding clamp of the cylinder (see photo). 3....

Sliding sunroof — general information
1. On some Peugeot 305 models, a sliding sunroof is a factory option. The mounting parts of the hatch are shown in B/Figure 11.20. 2. Maintenance of the hatch consists of checking the condition and reliability of...

Removal and installation the trunk lid stop (Salon models)
1. Remove the right rear door seal where it extends to the rear compartment panel. Remove the rear seat back and rear compartment panel trim. 2. Lift the trunk lid up to the stop and support it in this position. 3....

Removal and installation the tailgate (Estate models)
1. Disconnect the ground cable from the battery. 2. Open the inspection cover on the left side of the luggage compartment. Pull out and disconnect the rear tailgate wiring connectors. Tie a piece of string to the wiring...

Front radiator grille — removal and installation
1. The plastic grille in front of the radiator is held in place by 2 rotary clips. 2. To remove the grille, lift the hood and turn the 2 clamps securing the top of the grille. Pull the grille out of the lower mountings...

Front and rear bumpers — removal and installation
1. To remove the bumper, unscrew and remove the end fastening bolts under the wheel arches (front bumper) or in the trunk (rear bumper). Loosen and remove the main mounting bolts. Remove the bumper from the car. 2....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Body and interior: Exterior (external elements) Peugeot 106 (1991-2003)
➨ Body and interior: Exterior (external elements) Peugeot 207 (2006-2014)
➨ Body and interior: Exterior (external elements) Peugeot 406 (1995-2004)
➨ Body and interior: Exterior (external elements) Peugeot 807 (2002-2014)

Link to this section in different formats

TEXTHTMLBB Code