2. Remove the inner door trim (see previous section).
3. Remove the Phillips screw on the front edge of the door latch release mechanism, pull the mechanism forward to disengage it from the door, then disconnect the link and remove the mechanism (see photo).
4. Lower the glass, remove the front triangular plastic trim, pull the glass seals out of their clips in the door and remove the seals (see photo).
5. Remove the bolts in the front and rear lower corners of the door (see pictures), fixing the glass guide troughs.
6. Do not fully raise the glass and loosen 5 nuts securing the power window mechanism in the door frame (see photo).
7. Support the glass, remove the nuts securing the power window mechanism and disconnect the power window roller from the lower glass channel with the glass still supported, remove the power window mechanism (see photo).
8. Tilt the glass and carefully pull it out (see photo).
9. Clean the power window mechanism and inspect it for wear. The presence of parts for it is not available for sale, so in the event of a malfunction, you will have to replace the entire power window assembly. Lubricate all moving parts before reinstalling window regulator (see photo).
10. Installing the glass and the power window mechanism is done in reverse order. Check that the seals fit into their clips. Before installing the door trim, check the operation of the power window.