General information about the clutch The clutch is located between the engine and gearbox and is designed for short-term separation and subsequent smooth connection of the crankshaft of the engine and the input shaft of the gearbox while starting the car...
Replacing the hydraulic clutch To remove the hydraulic clutch actuator: remove the air filter and the air pipe connecting the air filter and the engine; remove the decorative engine cover; remove the cap from the reservoir with brake fluid and pump...
Clutch Disc Replacement To remove the clutch disc: remove the gearbox; mark with a marker or paint the position of the clutch assembly in relation to the flywheel; using a special tool or a screwdriver, use the teeth of the flywheel ring gear...
General information about drive shafts Torque from the gearbox to the drive wheels is transmitted using steel axle shafts of different lengths. Each half shaft consists of three parts: internal and external hinges of equal angular velocities (SHRUS) and the...
Replacement of half shafts To remove the half shaft: with the vehicle on the ground, apply the parking brake and loosen the front wheel mounting bolts; raise the car on a lift; remove the front wheels; Pic. 6.7. Fastening the device that fixes...
Replacement of constant velocity joints To replace the outer joint: remove the axle shaft; secure the axle shaft in a vice with soft jaws and remove the clamps securing the cover. slide the protective cover along the semiaxis; using a hammer or soft drift,...
Replacement of the intermediate bearing of the right semiaxis Attention! To remove the bearing, you must use a special puller. To replace the intermediate bearing of the right axle shaft: remove the right half shaft; check the condition of the bearing, which should rotate easily...