Interior (internal body elements) Peugeot 305

Interior door trim — removal and installation
1. Door trim removal and installation is the same on all four doors. The procedure for removing and installing the front left door trim on SR models is shown in the attached photographs. 2. Unscrew the lock button (see...

Heater core — removal and installation
1. If necessary, the heater core can be removed separately, although this will not significantly reduce the amount of work compared to removing the heater assembly. 2. Follow the instructions in the section on removing...

Removal and installation seats
Front seats 1. The tubular seat frame is attached to the guides using studs and nuts. The guides are secured to the floor with Allen head screws. 2. To remove the seat, move it all the way forward and unscrew the rear...

Seat belts — description and maintenance
1. All models are equipped with inertia-reel seat belts for the front seats. 2. Depending on the model, both inertia-reel and regular seat belts can be used in the rear seats. 3. Seat belts can be installed on the rear...

Modification of front seat belt anchorages (all models)
1. On pre-1985 models, the front seat inertia reel reel is secured with 4 bolts and vibration-resistant washers. In 1985, the transition was made from 4 bolts to 2, with each bolt being fitted with a conical and a plain...

Glove Compartment Latch Repair (Pre-1983 Models)
1. If the glove compartment latch is broken, it can be repaired using a reinforcing plate shaped as shown in B/Figure 12.141. 2 mm thick mild sheet steel can be used to make the plate. 2. Install the plate on the latch...

Torpedo — removal and installation
1. Removing the dashboard is a fairly simple job, but involves many small operations. It's essential to work methodically and carefully record details such as wire routing, bolt locations and lengths, grounding...

Windshield — removal and installation
1. It is recommended to entrust the replacement of the windshield to a specialist. If you still want to do this work on your own, please read the instructions below. 2. Cover the hood, dashboard and front seats with...

Interior heater — removal and installation
1. Disconnect the ground cable from the battery. 2. Remove the shelves under the dashboard on both sides of the heater. Loosen the heater cover mounting screws and remove the cover, disconnecting the hazard warning...

Removal and installation the heater (models produced since 1983)
1. Disconnect the ground cable from the battery. 2. Remove the trim around the gear shift lever by lifting up the new cover and sliding the trim back. Underneath it are 2 screws that secure the rear of the center...

Plastic parts
Plastic is widely used in modern cars (bumpers, spoilers and sometimes even structural body parts). If such parts are damaged, it is better to entrust their repair to a specialist, as it requires special equipment. The...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Body and interior: Interior (internal elements) Peugeot 106 (1991-2003)
➨ Body and interior: Interior (internal elements) Peugeot 207 (2006-2014)
➨ Body and interior: Interior (internal elements) Peugeot 405 (1987-1997)
➨ Body and interior: Interior (internal elements) Peugeot Partner I (1996-2008)

Link to this section in different formats

TEXTHTMLBB Code