Attention! This operation requires special attention. Be careful.
Remove the wiring harness in the following order:
- remove the air filter assembly;
Pic. 6.115. Removing the hydraulic unit wiring harness: 1 - pin connector; 2 - clamp; 3 - hydraulic block
- unscrew bolts of fastening of a socket 1 (pic. 6.115) yellow color;
- disconnect clamp 2;
- raise the car on a lift;
- place a container under the gearbox to collect the working fluid;
- unscrew the bolts securing the hydraulic unit 3 and remove it;
Pic. 6.116. Wiring harness connectors: 1 - pin connectors
- disconnect connectors 1 (pic. 6.116) wiring harness using a screwdriver as a lever.
Installation of a plait of wires carry out in sequence, return to removal. Top up the fluid level with fresh fluid.