Table of contents: Removal 🠇 Installation 🠇
Note: The following procedure applies to Peugeot/Citroen original equipment.
Removal
1. Turn off the audio unit and ignition.
2. Original Peugeot/Citroen audio units have DIN-compliant mounting elements. Removal requires two special tools, which can be purchased at most auto parts stores. Alternatively, suitable tools can be made from 3 mm diameter wire, such as welding electrode.
3. Insert the tools into the holes on each side of the audio unit and push them in until they lock into place. The audio unit can be removed from the front panel (figure 17.3).
Figure 17.3. Insert the pullers into the holes on the audio block and remove the block from the front panel
4. After removing the audio unit from the front panel, disconnect the electrical connectors and disconnect the antenna wire from the rear side. Remove the audio unit from the vehicle.
5. To remove the support frame on pre-September 2002 models, use a small screwdriver to release the mounting tabs on each side of the block (figure 17.5). Please note that this procedure will cause the frame to be slightly warped, but can be straightened after removal.
Figure 17.5. On early models, use a small screwdriver to release the frame mounting tabs...
6. After releasing the mounting tabs, remove the frame from the front panel (figure 17.6).
[Article based on material from the website: Peugeotbook.ru]
Figure 17.6. ...then remove the support frame from the front panel
Installation
7. If applicable, secure the support frame in its normal position.
8. Securely connect the antenna wire and mat the electrical connectors, then insert the unit into its original location, being careful not to pinch the electrical wiring.