Washer reservoir
2. Release bolts of fastening of the right forward wheel. Raise the front of the vehicle and securely jack stands under it (see «Lifting and placing the car on supports»). Remove the right wheel.
3. Working from under the front fender, remove the screws, remove the clips and remove the wheel arch locker from the fender panel..
4. Mark the installation position of the washer hoses (if necessary, mark the hoses themselves to identify them), and then disconnect the hoses from the pump (-ov) washer.
5. Disconnect the electrical connector on the pump (-Oh) washer.
6. Unscrew the top and bottom nuts, and then remove the tank from under the bottom of the wing (pic. 16.6, a, b).
Pic. 16.6, a. Top nut (marked with an arrow)...
Ryas. 16.6, b....lower nut (marked with an arrow) washer reservoir mounts
7. Installation is carried out in the reverse order of removal. Connect all hoses securely. Fill the reservoir and check the lines for leaks.
Washer pump
8. Proceed as described in p.p. 2-5. Disconnect the hose (-And) and disconnect the electrical connector on the pump.
9. Install a suitable container under the reservoir to collect the washer fluid, which may leak when the pump is removed.
10. Carefully remove the pump from the tank and remove its sealing sleeve. Wash off any spilled liquid with cold water..
11. Installation is carried out in the reverse order of removal. Use a new sealing sleeve if «old» shows signs of damage or deterioration. Finally, fill the reservoir and check the pump o-ring for leaks.
Windshield washer nozzle
12. Open the hood and support it.
13. Disconnect the hose (-And) washer from the corresponding nozzle, and then press the latches and remove the nozzle from its normal position.
14. When installing, fix the nozzle in the hood and connect the hose. The direction of the washer nozzle jet is not adjustable.
Tailgate washer nozzle
15. The tailgate washer nozzle is integrated with the wiper.