Drive shafts of the front wheels of the car Peugeot 206

General information about front wheel drive shafts
Figure 6.123. GKN outer joint The front wheel drive consists of an outer and inner constant velocity joint (CV joint) connected to each other by a shaft. The outer joint transmits torque and provides angular movements...

Removal and installation the front wheel drive (models with automatic transmission)
Remove the front wheel drive in the following order: Attention! The automatic transmission is sealed, so for this operation it is not necessary to drain the working fluid from the transmission. Figure 6.133. Installing...

Removal and installation front wheel drive (models with manual transmission)
Remove the front wheel drive in the following order: Figure 6.133. Installing the spring retaining rods: 1 - traction; 2 - spring install rods 1 on both sides of the car (see figure 6.133), retaining springs 2 shock...

Replacing mudguards on a GKN drive
When replacing front wheel drive covers, Peugeot service centres use the following special tool: shaft support - 0403-R; shaft retaining sleeve 0410-D, 4101-D, 0410-F, 4518-T; mudguard installation device - 0410-M;...

Replacement of mudguards on the drive manufactured by PSA
When replacing front wheel drive covers, Peugeot service centres use the following special tool: inertial puller 0316-A, 1671-T; threaded sleeve for removal 0410-A, 4083-T; threaded sleeve for removing BOXER/JUMPER...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Transmission: Drive shafts Peugeot 106 (1991-2003)
➨ Transmission: Shafts, hubs and wheels Peugeot 305 (1977-1989)
➨ Transmission: Drive shafts Peugeot 405 (1987-1997)
➨ Transmission: Drive shafts Peugeot Partner I (1996-2008)

Link to this section in different formats

TEXTHTMLBB Code