Vehicle headlights and lighting fixtures Peugeot 207

General information about the lighting system
The Peugeot 207 can be equipped with the following functions (depending on the equipment level): automatic activation of hazard warning lights; controlled headlights; pulse control of fog lights; automatic switching on...

Steering column switch
The switching module under the steering wheel is a monoblock that contains: a light switch (1), a support (2) and a windshield wiper switch (3). The switching module under the steering wheel transmits driver actions to...

Controlled headlights
Controlled headlight: 1 - ECU for controlled headlights; 2 - low beam lamps; 3 - high beam lamps; 4 - optical block; 5 - headlights with directional light distribution. Controlled headlight system (adaptive lighting)...

Automatic activation of hazard warning lights
Automatic hazard warning lights enhance safety by alerting you to sudden deceleration or a collision, and are activated during sudden braking or impact (triggering of a pyrotechnic element).

Dual light and rain sensor
The dual light and rain sensor "a" transmits information about the outside light and determines the amount of water on the windshield. The sensor also transmits infrared radiation information, which is necessary for the...

Electrical characteristics of the light and rain sensor
Black 4-pin electrical connector "j": "j1" — channel 1 +BAT connected; "j2" - channel 2 CAN CAR High; "j3" - channel 3 "ground"; "j4" — channel 4 CAN CAR Low. The range of temperatures in the car interior acceptable for...

Teleloading — General Information
The rain and outdoor light sensor needs to be teleloaded to adjust its sensitivity. No further adjustments are required. Note: After replacing the windshield (or rain sensor and outdoor lighting brightness) it is...

Light sensor malfunction with automatic headlight control function enabled
If a sensor malfunction is detected while the automatic mode is on, the light remains on until the ignition is turned off. If the lighting devices were already on at the time the fault was detected, they will also...

Headlight adjustment (normal lighting)
Note: Use one of the following tools to make adjustments: - "Facom LUX 200L"; - "Muller 664"; - "Laser Tecnotest 432/PM". Preliminary operations Unload the car. The car must be in running order. Remove any accumulations...

Outdoor Lighting Diagnostics
Note: This chapter covers diagnostic trouble codes displayed by Lexia and Proxia equipment. The cars in the configuration are considered "Full CAN PSA", equipped with a steering column switching module (COM 200x). Body...

Replacing the headlight assembly
Removal Disconnect the battery. Remove the front bumper (see section " Body "). Disconnect the connector (1) (9-pin black). Unscrew the three mounting screws (2) and remove the headlight (3). Installation Install the...

Replacement and adjustment of front fog lights
Perform the following operations: turn off the ignition; wait 3 minutes before disconnecting the battery; disconnect the battery. Remove the front wheels and mudguards. Left side Disconnect the connector (in area "a")....

Emergency operating modes
Automatic switching on of low beam headlights Front fog lights

Fault codes related to the exterior lighting system (BSI 1 switch unit)
Note: This chapter covers diagnostic trouble codes displayed by Lexis and Proxia equipment.

Exterior Lighting System Related Fault Codes (BSM Engine Switch Module)
Note: This chapter covers diagnostic trouble codes displayed by Lexia and Proxia equipment.

Error codes related to the operation of the rain and outside light sensor

Replacing the rear combination light (hatchback)
Removal Remove the mount (1) (on each side). Remove the rear light (2) by pulling it towards you. Disconnect the connector (3) (on each side). Remove the rear light (2). Installation Install the parts in reverse order.

Replacing the rear combination light (station wagon)
Removal Remove the cover (1) (in area "a"). Disconnect the connector (in area "b"). Unscrew the wing nut (2) from the inside of the luggage compartment. Remove the rear light (3) (as shown by the arrow). Installation...

Replacing the additional brake light (hatchback)
Removal Perform the following operations: turn off the ignition; wait 3 minutes before disconnecting the battery; disconnect the battery. Press on the tips (A) to release the fasteners in area "B". Disconnect the...

Replacing the additional brake light (station wagon)
Removal Perform the following operations: turn off the ignition; wait 3 minutes before disconnecting the battery; disconnect the battery. Open the tailgate and unscrew the nuts (1). Close the tailgate. Pull the...

Removal and installation the front lighting control unit and alarm sensor (hatchback)
Removal Perform the following operations: turn off the ignition; wait three minutes before disconnecting the battery; disconnect the battery. Disconnect the retaining springs (1) of the block (2). Slide the block...

Removal and installation the front lighting control unit and alarm sensor (station wagon)
Removal Perform the following operations: turn off the ignition; wait three minutes before disconnecting the battery; disconnect the battery. Release the block fastenings (1) (in area "a"). Slide the block cover off....

Removal and installation the rain and light sensor and the interior rearview mirror
Turn off the ignition. Wait 3 minutes before disconnecting the battery. Disconnect the battery. Remove the front lighting control unit. Detach the mirror (1), slide it in direction "a" and remove it. Disconnect the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Electrical equipment: Headlights and lighting Peugeot 305 (1977-1989)

Link to this section in different formats

TEXTHTMLBB Code