Automatic transmission — general description Models with 2.0 liter petrol engines can be equipped with a computer that controls a four-speed automatic transmission consisting of a torque converter, gear train and hydraulically controlled clutch and brakes. The...
Specifications of automatic transmission Type automatic, 4 forward gears and 1 reverse Designation 4 HP 20 The amount of oil in the gearbox: - when changing oil 3.0 liters – total capacity including torque converter 8.3 liters Tightening torques, Nm Cooler...
Changing the oil in the gearbox 1. Take a short drive to bring the transmission up to operating temperature. 2. Install the car on a lift or over a viewing hole. 3. Remove the oil level gauge, then place a suitable container under the transmission...
Removal and installation of a cable of the selector Removing 1. Remove the air filter housing. 2. Set the selector lever to position "P". 3. In the engine compartment, use a lever to remove the cable ball joint from the selector lever on the multifunction transmission...
Removal and installation of the speedometer drive Removing 1. Raise the front of the car and secure it on stands. Remove the mudguard from under the engine. The speedometer drive is located at the rear of the gearbox housing near the inner end of the right drive shaft....
Removal and installation of a cooler Gearbox cooler 3. Cooler; 4. Mounting bolts; 5. Gaskets; 6. Washer Removing 1. The cooler is mounted on top of the gearbox housing. To access the cooler, remove the air filter housing and intake passages. 2. Disconnect...
Removing and installing the multifunction switch Removing 1. To improve access to the switch, remove the air filter housing and intake passages. 2. Set the selector lever to position "N". 3. Mark the position of the selector lever relative to the switch. 4. Using a...
Removal and installation of the electronic control unit (ECU) The automatic transmission ECU control unit, together with the ECU engine control unit, is located in the ECU box in the right front side of the engine compartment next to the coolant expansion tank. Removing 1. Turn...
Removal and installation of an automatic transmission Removing 1. Remove the battery box to install the battery. 2. Remove the air filter housing and intake pipe system. 3. Raise the front of the car and secure it on stands. Remove the front wheel and wheel arch...
Overhaul of automatic transmission The gearbox is a very complex unit, and it must be repaired in a specialized workshop. Before repairing the transmission, it is necessary to determine the nature of the malfunction, which can be electrical, mechanical...
The main malfunctions of an automatic transmission Due to the fact that the automatic transmission is a very complex unit, it is necessary to contact a service station to diagnose malfunctions and service the transmission. Oil leaks The oil used in the gearbox is...