Car steering Peugeot 406

Steering wheel — removal and installation
Please note: Vehicles equipped with a driver's side airbag have the word AIRBAG imprinted on the steering wheel pad. Models without airbag Removal 1. Set the front wheels to move straight ahead. 2. Using a lever, remove...

Steering column — removal, inspection and installation
Removal 1. Remove the negative terminal from the battery. 2. Remove the steering wheel. On vehicles with an airbag, remove the connector from the top of the steering column. 3. On all models, remove the switch from the...

Intermediate shaft of the steering column — removal, inspection and installation
Removal 1. Remove the steering column. 2. Raise the front of the vehicle and support it on stands. 3. Apply alignment marks to the intermediate shaft and steering gear pinion. Unscrew the clamping nut and intermediate...

Ignition switch — removal and installation
Ignition switch contact group Removal 1. Remove the negative terminal from the battery. 2. Open the key block cover and disconnect the electrical connector. Turn the clamp 90° and remove the fuse box cover. Unscrew the...

Steering gear — removal and installation
Removal 1. Raise the front of the car and secure it on stands. Remove the front wheels. 2. Remove the cable and heat shield from the top of the steering gear. If present, release the retaining clip and disconnect the...

Replacing the steering gear protective covers
1. Remove the steering tie rod ball joint. 2. Mark the location of the protective boot on the steering rod. Release the clamps and slide the protective boot from the steering gear housing to the end of the steering rod....

Bleeding the Power Steering System
Air must be removed from the system after disconnecting the hydraulic elements of the system. 1. Remove the filler cap from the tank and check the fluid level. 2. With the engine off, slowly turn the steering wheel from...

Power Steering Pump — Removal and Installation
Removal 1. Loosen the drive belt and remove the belt from the pump pulley. The power steering pump is located above or below the alternator, depending on the engine type. If the pump is located below the alternator, it...

Steering Tie Rod Ball Joint — Removal and Installation
Removal 1. Raise the front of the vehicle and secure it on stands. Remove the relevant front wheel. 2. Using a scriber, mark the position of the ball joint on the tie rod. 3. Lock the tie rod and back off the ball joint...

Steering rod — removal and installation
Attention! To remove the inner ball joint of the steering rod from the toothed rack, it is necessary to use a special Peugeot spanner No.0707. Removal 1. Remove the steering tie rod ball joint. 2. Loosen the clamps and...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Chassis, running gear: Steering Peugeot 106 (1991-2003)
➨ Chassis, running gear: Steering Peugeot 207 (2006-2014)
➨ Chassis, running gear: Steering system Peugeot 306 (1993-2002)
➨ Chassis, running gear: Steering Peugeot 605 (1989-2000)
➨ Chassis, running gear: Steering system Peugeot J5 (1981-1993)

Link to this section in different formats

TEXTHTMLBB Code