Technical characteristics of electrical equipment Battery 12 V, 200 A Generator The three-phase generator has a built-in electronic regulator. Brand and type: Bosch 0 120 489 29; Mitsubishi A 002 T 27 091; Paris-Rhone A 13 N 95. Generator belt Brand and type Hutchinson...
Open Circuit Detection Warning! Before starting work on any of the elements of the vehicle's electrical system, it is necessary to disconnect the wire from the negative terminal of the battery to prevent a short circuit and / or fire during...
Generator — removal and installation Generator (A - Bosch, B - Mitsubishi, C - Valeo) 1 - pulley, 2 - fan, 3 - front housing, 4 - bearing, 5 - rotor, 6 - stator, 7 - brush holder-regulator, 8 - rear housing, 9 - rectifier unit Removing the generator 1 -...
Switch Replacement Multifunction steering column switches (models up to 1993) 1. Remove steering column covers. 2. Unscrew two screws (indicated by arrows) fastening the switch to the steering column bracket. 3. Remove the switch and...
Oil level and temperature sensor Oil level sensor The oil level sensor is located on the front side of the cylinder block to the right of the oil filter or on the rear left side of the cylinder block. Access to the sensor is most convenient from the...
External lighting bulbs Attention! Before replacing exterior light bulbs, check the appropriate electrical circuit and fuse. Attention! Do not touch the glass bulb of the lamp with your hands. The fingerprint evaporates and is deposited on the...
Interior lighting bulbs Attention! Before replacing interior light bulbs, check the appropriate electrical circuit and fuse. Lamps for interior lighting, glove box and trunk lighting 1. Using a thin screwdriver, remove the cover from the...
External lighting devices — removal and installation Attention! Disconnect the negative cable from the battery before removing any light fixture and reconnect the negative cable to the battery after installing the light fixture. Farah Attention! Before removing the...
Headlight adjustment Headlight with corrector 1 - headlight housing, 2 - light-diffusing glass of the headlight, 3 - light bulb, 4 - cylinder, 5 - tubes, 6 - corrector, 7 - control knob Headlight adjustment elements 1 - horizontal...
Instrument cluster — removal and installation Instrument cluster 1 - casing glass, 2 - indicator board, 3 - tachometer (or watch), 4 - speedometer, 5 - housing, 6 - drive cable Models up to 1993 1. Disconnect the negative cable from the battery. 2. Move the...
Instrument cluster elements — removal Models up to 1993 1. Remove the clamps and unscrew the three screws securing the glass frame. 2. Unscrew the screws and remove the cover from the back of the instrument cluster. Models since 1993 3. Unscrew two screws...
Clock — removal and installation Models up to 1992 Removing 1. Disconnect the negative cable from the battery. 2. Remove the three locking plates located under the ventilation nozzles and covering the screws securing the instrument cluster shield. 3....
Wiper arms — removal and installation Removing 1. Using a piece of chalk or a strip of tape, mark the position of the wiper arms in their original position. 2. Start the wiper motor and turn it off when the wiper arms return to their original position. 3....
Wiper motor and traction — removal and installation Windshield brush assembly 1 - holder with articulated mechanism, 2 - motor, 3 - crank, 4 - connectors, 5 - wiper shaft, 6 - brush holders, 7 - brush Installing the Wiper Drive Assembly 1 - engine, 2 - connector, 3 -...
Rear door wiper motor Removing 1. Disconnect the negative cable from the battery. 2. Remove the wiper arm. 3. Loosen the large spindle nut. 4. Open back door. 5. Unscrew the mounting screws and remove the plastic trim from the inside of the...
Windshield washers — removal and installation Windshield and headlight washer reservoir The tank is located in the right rear corner of the engine compartment. Removing 1. Disconnect the negative cable from the battery, then disconnect the electrical wiring from...
Radio receiver — removal and installation Radio receiver with DIN clips Removing 1. Disconnect the negative cable from the battery. 2. Remove the plastic plugs from both sides of the radio. 3. Two special U-shaped tools are required to remove the radio. Insert...
Loudspeakers — removal and installation Loudspeakers installed in the door 1. Disconnect the negative cable from the battery. 2. Remove the loudspeaker grille by prying it from below with a thin screwdriver or by unscrewing the three screws. 3. unscrew the...
Radio antenna — removal and installation Roof mounted antenna The antenna can simply be unscrewed from the base. To remove the included antenna, follow these steps: 1. Disconnect the negative cable from the battery. 2. Remove sun visors from overhead console....
Anti-theft system Attention! This information only applies to the anti-theft system installed by Peugeot as standard equipment. The anti-theft system is turned on and off by a miniature transmitter. After turning on the system, the...
Airbag Vehicles equipped with a driver's side airbag have the word "AIRBAG" on the center of the steering wheel. If there is an airbag on the front passenger side, there is a word on the top of the instrument panel "AIRBAG"....
Airbag elements — removal and installation The airbag sensors are integrated with an electronic control device that is independently integral with the steering wheel. Airbag warning light integral with airbag unit. Airbag electronic control device The electronic...
Heating and ventilation system — removal and installation Heating and ventilation system 1 - air distribution box, 2 - heater radiator, 3 - air supply housing, 4 - fan Heater radiator 1 - housing of the ventilation system, 2 - heater radiator, 3 - fastening screws, 4 - branch...