Table of contents: Roof mounted antenna 🠇 Antenna mounted on the rear fender…🠇 Antenna mounted on the rear fender…🠇
Roof mounted antenna
The antenna can simply be unscrewed from the base. To remove the antenna in the kit, you must perform the following steps.
1. Disconnect the negative cable from the battery.
2. Remove the sun visors from the overhead console.
3. Remove the backlight switch from the remote control to access the two screws. Disconnect the connector and remove the backlight switch.
4. Remove the backlight lamp shade from the remote control to access the screw. Disconnect the connector and remove the backlight lamp.
5. Using the lever, remove the locking plate from the remote control, and also remove the hatch switch from the remote control.
6. Unscrew the two screws securing the remote control, then lower the remote control from the ceiling.
7. Use a lever to remove the insulator (indicated by the arrow) from the base of the antenna.
8. Unscrew the mounting nut, disconnect the antenna wire and remove the antenna from the roof.
9. Installation is carried out in the reverse order of removal.
Antenna mounted on the rear fender (sedan models)
1. Retract the antenna completely.
Source can be seen at (PeugeotBook.ru)
2. Working in the luggage compartment, remove the trim from the left side of the trunk.
3. Disconnect the antenna (A) and ground (B) wires from the antenna base. On models with an electric antenna drive, disconnect the electrical connector from the antenna drive.
4. Unscrew the lower antenna mounting bolt.
5. At the top of the antenna, unscrew the round nut that secures the antenna to the top of the rear wing.
6. Remove the sealing cap.
7. Remove the antenna into the luggage compartment.
8. Installation is carried out in the reverse order of removal.
Antenna mounted on the rear fender (combi models)
The antenna is removed in the same way as on Sedan cars (see higher), but the top end of the antenna is secured with a sealing ring instead of a round nut.
1. Disconnect the antenna drive electrical connector.
2. Unscrew the antenna mounting bolt.
3. When removing the antenna, simply pass the antenna down through the sealing ring.