Radio receiver — removal and installation (Peugeot 405)

Table of contents: Radio receiver with DIN clamps 🠇 Radio receiver with "Peugeot" clamps 🠇

Radio receiver with DIN clamps

Removal

1. Disconnect the negative cable from the battery.

2. Remove the plastic plugs from both sides of the radio.

3. To remove the radio, you will need two special U-shaped tools. Insert the two special U-shaped tools on the right and left into the holes on the front panel of the radio.

4. Press the special tool slightly outward, which will press the fastening brackets inward.

5. In this position, pull out the radio receiver with uniform force. When pulling out, do not tilt the radio receiver.

6. Mark and disconnect the connectors and antenna plug.

7. Remove the pullers by squeezing the fasteners with a small screwdriver.

7. Remove the pullers by squeezing the fasteners with a small screwdriver.

8. Remove the radio.

Installation

Installation is carried out in the reverse order of removal.

Radio receiver with "Peugeot" clamps

Removal

1. Disconnect the negative cable from the battery.

2. Open the cover that covers the radio receiver.

3. Remove the trim plate above the radio to access the two holes that accept the radio removal tools.

4. To remove the radio, you need to use a special tool or two rods with grooves on the end that connect to the mounting brackets.

4. To remove the radio, you need to use a special tool or two rods with grooves on the end that…

5. Insert special tool (indicated by the arrow) or two rods with grooves on the end into the holes in the top of the radio until they connect to the mounting brackets and release the radio mounting brackets.