Coolant drain (diesel) Cooling system 1 - radiator with expansion tank, 2 - coolant pump, 3 - thermostat housing, 4 - thermostat cover, 5 - thermostat, 6 - fan motor, 7 - fan, 8 - fan temperature sensor, 9 - coolant temperature sensor, 10 -...
Filling coolant and bleeding (diesel) Cooling system deaerator and fan fuses Pic. A: 1 - deaerator of the cooling system Pic. B: 1 - cooling system deaerator, 2 - fan fuses Installing a thermostat 1. Open deaerators. 2. Fill the cooling system through the...
Removal and installation of the pump of a cooling liquid (diesel) The coolant pump can be removed and installed in the vehicle after the timing belt has been removed. 1. Unscrew the five pump mounting bolts and remove its seal. 2. The pulley-housing-impeller assembly is non-separable....
Oil pump — removal, inspection and installation Unscrewing the oil pump cover Removing the spring Removing the relief valve piston Removing 1. Remove oil pan. 2. Remove the three bolts securing the oil pump to the cylinder block. 3. Remove the pump sprocket from the...
Oil cooler — removal and installation Radiator mounting bolt and mounting groove A - radiator mounting bolt B - installation groove Removal and installation 1. Raise the front of the car. 2. Drain the coolant from the system or pinch the coolant supply...
Oil pressure check 1. Remove the oil pressure sensor. 2. Connect a pressure gauge to check the pressure. 3. Start the engine and warm it up to operating temperature. 4. Write down the pressure values and compare with those that should be....
Cooling system — design description Cooling system 1 - radiator; 2 - thermostat; 3 - thermostat housing; 4 - housing for connecting pipelines; 5 - separating element; 6 - coolant pump; 7 - pipelines of the cooling system; 8 - pipelines for heating the...
Coolant hoses Fastening pipelines to the radiator with latches 1 - radiator, 2 - pipeline, 3 - round sealing ring Since January 1990, some vehicles have been equipped with radiators with pipes connected with special clip-on lugs...
Radiator — removal, inspection and installation Removing 1. Disconnect the negative cable from the battery. 2. If equipped, disconnect the connector from the coolant level sensor located on the right side of the radiator. 3. If equipped, disconnect the connector from...
Thermostat — removal, inspection and installation Bolts of fastening of a cover of the thermostat, engine 1,4 l Mounting bolts are indicated by arrows. Bolts of fastening of a cover of the thermostat, engine 2,0 l The fastening bolt is indicated by an arrow. Removing...
Radiator cooling fan — removal, inspection and installation The voltage to the fan is supplied through the ignition switch, fuse and thermal switch, which (on most models) installed in the radiator. On models with air conditioning, the cooling fans are controlled by a sensor...
Coolant pump — removal and installation Removing 1. Drain the cooling system. 2. Remove the timing belt drive timing. 3. Remove the toothed belt tensioner and rear belt guard. 4. Unscrew the mounting bolts and remove the pump. The most convenient access to...
Coolant drain 1. Remove the coolant drain and fill plugs from the radiator. 2. Remove drain plug (arrow) coolant from the engine block (it is located on the pipe connection housing behind the coolant pump). 3. Reinstall the drain...
Filling the coolant and removing air from the system Deaerator on the radiator The deaerator is shown by an arrow. Deaerator on the thermostat housing Replaceable Radiator Fan Motor Fuse The replaceable fuse is indicated by an arrow. 1. Check the fastening of the coolant...