The coolant pump can be removed and installed in the vehicle after removing the timing belt.
1. Unscrew the five pump mounting bolts and remove its seal.
2. The pulley-housing-impeller assembly is non-separable.
3. Before installing the pump, clean the connection surface. Install the pump with a new seal.
4. Tighten the bolts to 10 Nm.
Removal and installation the coolant pump (diesel) (Peugeot 405)
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Article reviewed by editor: Shirokov Arseny
Share information:
See similar information for other Peugeot models
➨ Coolant pump — removal and refitting Peugeot 106 (1991-2003)
➨ Replacing the coolant pump (diesel engines) Peugeot 207 (2006-2014)
➨ Fuel injection pump (Lucas CAV/Roto-Diesel) — checking and… Peugeot 305 (1977-1989)
➨ Engine compartment. Cars with a 2.1L diesel engine Peugeot 605 (1989-2000)
➨ Vacuum Pump (Diesel Engine Models) — removal and installation Peugeot Partner I (1996-2008)
Link to this article in different formats
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance (gasoline)
- Maintenance (diesel)
- Power unit
- Gasoline engines
- Diesel engines
- Engine overhaul
- Cooling and heating
- Fuel system (gasoline)
- Fuel system (diesel)
- Engine electrical equipment
- Transmission
- Clutch and drive shafts
- Mechanical gearbox
- Automatic gearbox
- Chassis, running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits
- General information
- User manual
- Maintenance
- Power unit
- Petrol engines 1.4 l
- Petrol engines 1.6-2.0 l
- Diesel engines
- Ignition system
- Fuel system (carburetor)
- Single point fuel injection
- Multipoint fuel injection
- Cooling and lubrication system
- Exhaust system
- Transmission
- Clutch
- Manual gearbox MA
- Manual gearbox BE
- Automatic gearbox
- Drive shafts
- Chassis, running gear
- Steering
- Front suspension
- Rear suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits