Doors, locks and windows of the car Peugeot 406

Doors — removal, installation and adjustment
Removal 1. Remove the negative terminal from the battery. Front door 2. If the door contains any electrical components, remove the door trim and protective film. 3. Disconnect the connectors from the electrical...

Door trim — removal and installation
Please note! Door trim may vary depending on trim level. Therefore, the trim removal process may differ from that described. Removal 1. Remove the negative terminal from the battery. Front door 2. Remove the decorative...

Door lock and handles — removal and installation
1. Remove the door trim. 2. To access the door handle and lock, remove the protective film from the door. Internal door opening handle Caution: When reinstalling the inside door handle, new rivets must be used. 3. Trim...

Door glass — removal and installation
Caution: New rivets must be used to reinstall the armrest suspension. Removal 1. Lower the window and remove the door trim. 2. After marking the location, drill out the heads of the rivets that secure the armrest...

Trunk lid — removal and installation
Removal Trunk lid 1. Open the trunk lid and remove the negative terminal from the battery. 2. Remove the boot lid trim retaining clips. 3. Remove the trim. 4. Remove the fastening brackets from the protective cover of...

Trunk lock — removal and installation
Removal 1. Open the trunk lid and disconnect the negative terminal from the battery. 2. Remove the pins and trunk lid trim. Trunk lock 3. Unscrew the bolts (photo on the left), disconnect the rod (photo on the right)...

Rear door — removal and installation
Removal Back door 1. Remove the negative terminal from the battery. 2. Remove the rear door seal to access the electrical wires in the rear door. 3. Disconnect the electrical connectors (indicated by arrows) rear doors,...

Rear Door Lock — Removal and Installation
1. Remove the negative terminal from the battery. 2. Open the rear door, unscrew the screws and remove the inner door handle. 3. Using a screwdriver, remove the decorative cover of the inner button. 4. Remove the rear...

Central locking system — removal and installation
The central door lock motor is an integral part of the lock and cannot be replaced separately from the lock. Trunk lid lock motor 1. Open the trunk lid, remove the pins and remove the trunk trim. 2. Disconnect the...

Electric windows
Caution: If the battery was disconnected with the door window open, the system must be reprogrammed after the battery is reconnected. Reprogramming 1. Turn on the ignition and lower the window down. Hold the window down...

Windshield and rear glass
The glass is glued directly into the frame. This ensures the best possible streamlining of the body and reliable sealing against water leakage. In addition, frontal resistance and weight are reduced. In order to replace...

Sunroof in a car
Using a hex key to close an electric sunroof manually Due to the complexity of the sunroof drive mechanism, considerable experience and knowledge are required to restore, replace or adjust the sunroof components. Access...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Body and interior: Doors, locks and windows Peugeot 106 (1991-2003)
➨ Body and interior: Doors, locks and windows Peugeot 206 (1998-2012)
➨ Body and interior: Doors, locks and windows Peugeot 307 (2001-2008)
➨ Body and interior: Doors, locks and windows Peugeot Partner I (1996-2008)

Link to this section in different formats

TEXTHTMLBB Code