Table of contents: Removal 🠇 Installation 🠇
Removal
Back door
1. Remove the negative terminal from the battery.
2. Remove the rear door seal to access the electrical wires in the rear door.
3. Disconnect the electrical connectors (indicated by arrows) rear doors, which are located in the front of the left rear pillar.
4. Remove the sealing ring and remove the wiring harness from the body.
5. Disconnect the electrical connector (1), unscrew the screw securing the ground bus (2) to the right rear pillar.
6. Disconnect the washer hose, remove the sealing ring and remove the wires and washer hose.
7. Use a pencil to mark the position of each hinge on the rear door.
8. While supporting the rear door, remove the mounting brackets and detach the rear door support pillars.
9. Unscrew the bolts (indicated by arrows) fasteners and remove the rear door from the vehicle.
10. If the rear door hinges need to be replaced, mark their position with a pencil and remove the upper rear door trim inside the passenger compartment.
11. Supporting the headliner, unscrew the door hinge mounting nuts and remove them. Install the new hinges, aligning them with the marks made before removing the upper door trim.
Rear door support pillar
12. Remove the mounting brackets and disconnect the rear door support pillar from the ball joints.
Installation
Back door
1. Installation is performed in the reverse order of removal. In this case, it is necessary to align the hinges with the marks applied before removing the door.
Rear door support pillar
2. Installation is performed in the reverse order of removal. Check that the rack is securely fastened to the ball joints with the mounting brackets.