23. Remove the clutch (see relevant chapter).
24. Unscrew the bolts 6 fastening the flywheel and remove the flywheel 7 (see illustration).
5.24 Unscrew the bolts 6 fastening the flywheel and remove the flywheel 7
25. Remove the crankshaft rear oil seal.
26. Make sure that the seal seats are clean, if necessary, remove the remnants of the old sealant.
27. Lubricate the sealing lips of the new oil seal with clean engine oil. Do not lubricate the outer edge of the seal.
28. Stuff a new camshaft oil seal using a special tool «A», whose catalog number is 0187-N (see illustration).
5.28 Stuff a new camshaft oil seal using a special tool «A», whose catalog number is 0187-N
29. Install the flywheel, tighten the bolts of its fastening with a force of 20 Nm, and then tighten them by 60°.
30. Further, the installation of the dismantled components is carried out in the reverse order of removal.