Diesel engines series «XUD/DK5ATE» Peugeot 605

Specification of cars with diesel engines
Specification of cars with diesel engines

General information
Peugeot 605 cars can be equipped with four-cylinder diesel engines of the XUD series with a volume of 2.1 liters (see illustration 1.0), as well as a 2.5 liter DK5ATE engine (see illustration 1.0a). 1.0 XUD Series 2.1L...

Timing belt of the gas distribution mechanism drive — removal
Cars with 2.1L XUD series engines 1. Jack up the front of the car, place it on stands and remove the front right wheel and fender liner. 2. Disconnect the negative (-) battery terminal from the battery. 3. Remove the...

Timing belt of the gas distribution mechanism drive — installation
Cars with 2.1L XUD series engines 23. Check the condition of the timing belt for wear and mechanical damage 24. Check the ease of rotation of the rollers, make sure that they rotate smoothly, without jamming or noise....

Accessory Drive Belt — Removal
Cars with 2.1L XUD series engines 1. Disconnect the negative (-) battery terminal from the battery. 2. Move turbocharger hose 2 away from the work area (if provided), as well as the control unit 3 (see illustration)....

Accessory Drive Belt — Installation
Cars with 2.1L XUD series engines 11. Move the tension roller by the square 6 (see illustration 3.4). 12. Install the stop pin "a" (see illustration 3.4). 13. Place the belt on the accessory pulleys and corresponding...

Camshaft — Removal
Attention! The procedure is given using the example of cars with a 2.5 l DK5ATE engine. 1. Remove the vacuum pump 1 and then its gasket 2 from the exhaust manifold (see illustration). 4.1 Remove the vacuum pump 1 and...

Camshaft — Installation
The camshaft is installed in the reverse order of removal, taking into account the following. 17. Clean the sealing surfaces of the cylinder head and bearing housing, as well as the hole A of the camshaft position...

Cylinder head — general information
Cylinder head (see illustrations 5.0, 5.0a and 5.0b) is made of aluminum alloy and is attached to the cylinder block with 10 bolts together with the camshaft bearing housing. The bolt tightening sequence is shown in...

Power unit — removal and installation
Attention! The procedure is given using the example of cars with DK5ATE engine. 1. Drain the coolant. 2. Drain the transmission oil. 3. Drain the engine oil if necessary. 4. Remove the upper front cross member. 5. Press...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Power unit: Diesel engines Peugeot 106 (1991-2003)
➨ Power unit: Diesel engines Peugeot 206 (1998-2012)
➨ Power unit: Diesel engines Peugeot 305 (1977-1989)
➨ Power unit: Diesel engines Peugeot 406 (1995-2004)
➨ Power unit: Diesel engines Peugeot 806 (1994-2002)

Link to this section in different formats

TEXTHTMLBB Code