Vehicles with 2.1L XUD series engines
1. Disconnect the wire terminal «masses» (-) from the negative pole of the battery.
2. Move away from the place of work the hose 2 of the turbocharger (if provided), as well as control block 3 (see illustration).
3.2 Move away from the place of work the hose 2 of the turbocharger (if provided). as well as control unit 3
3. Remove the front right wheel and fender liner.
Attention. The accessory drive has a so-called dynamic tensioner that allows you to not only adjust the tension of the accessory drive belt, but also determine the timing of its replacement.
4. Turn the tensioner roller by inserting the appropriate lever into the square 6, move the roller away from the belt, thereby loosening its tension, and carefully remove the belt 7 from the pulleys of the auxiliary units (see illustration). Vehicles with 2.5L DK5ATE engine, power steering and air conditioning
3.4 Turn the tensioner roller by inserting the appropriate lever into the square 6, move the roller away from the belt, and carefully remove the belt 7
5. Remove the front right wheel and fender liner.
6. Detach support 1 (see illustration).
3.6 Detach support 1
7. Install thrust pin «A» diameter 4 mm (see illustration).
3.7 Install the thrust pin «A» diameter 4 mm
8. Loosen the bolt 2 fastening the tension roller 3 using a suitable wrench (see illustration 3.7).
9. Move the tension roller Z using the tool «b» to position A (see arrows in illustration 3.7), moving the roller away from the belt and thereby loosening its tension.
10. Carefully remove the belt from the accessory pulleys.