General information The brake system consists of a master brake cylinder, a vacuum brake booster, front and rear disc brakes. The hydraulic braking system is divided into two circuits (see illustration 1.0), which work diagonally, which...
Brake system — pumping Attention! Brake fluid is poisonous and must never be sucked out by mouth through a hose. If brake fluid comes into contact with the skin, immediately rinse the area thoroughly with water; If brake fluid gets into your...
Brake disc — removal Front brake disc 1. Jack up the front of the car, place it on jack stands. 2. Remove the corresponding front wheel. 3. Disconnect the wire terminal «masses» (-) from the negative pole of the battery. 4. Unscrew the...
Brake disc — check 10. Measure the residual thickness of the brake disc with a micrometer. Due to the fact that the surface of the brake disc wears unevenly, the measurement should be carried out at several points around the entire...
Brake pads — removal Attention! If the removed brake pads can be reinstalled, they should be marked accordingly to ensure that they are reinstalled. It is also recommended to note which block is internal and which is external. Otherwise,...
Brake pads — installation 9. Clean the seating and guide surfaces of the brake pads with a suitable soft metal brush or wipe with a cloth soaked in alcohol. Do not use solvents containing mineral oils or sharp-edged tools. 10. Check brake disc 6...
Brake caliper — removal Front wheel brake caliper 1. Jack up the front of the car, place it on jack stands, remove the corresponding front wheel. 2. Disconnect hose 1 from brake line 2 (see illustration). Plug the holes with suitable plugs....
Vacuum brake booster — removal and installation 1. Remove the cover of the ignition distributor and disconnect its wiring harness. 2. Remove slider 1 and bracket 2 of the plug (see illustration). 6.2 Remove slider 1 and bracket 2 of the plug 3. Disconnect the brake...
Parking brake pads — removal 1. Remove the brake disc. 2. Remove clamp 1 (see illustration). 7.2 Remove clip 1 3. Disconnect cable end 2 at point 3 (see illustration). 7.3 Disconnect cable end 2 at point 3 4. Disconnect cable 2 from the support...
Parking brake cable leash — removal and installation 1. Loosen lock nut 1, then unscrew nut 2 (see illustration). 8.1 Loosen lock nut 1, then unscrew nut 2 2. Disconnect the tip of the driver 3 from the equalizer 4 (see illustration 8.1). 3. Release the driver 3 from the...
Parking brake cables — removal and installation 1. Unscrew nut 1 (see illustration). 9.1 Unscrew nut 1 2. Release cable 3 from holder, disconnect cable 4 from equalizer 2 (see illustration 9.1). 3. Carefully disconnect the cables 5, remove the fastening springs 6 and...
Parking brake — adjustment 1. Jack up the rear of the car, place it on jack stands. 2. Release the parking brake. 3. Remove the rear brake discs (see relevant chapter). 4. Loosen locknut 1 (see illustration). 10.4 Loosen locknut 1 5. Loosen the...
Stoplight switch — removal and installation Removing 1. Remove the lower overlay under the instrument panel on the driver's side. 2. Disconnect the plug 1 and carefully remove the brake light switch 2 (see illustration). 11.2 Disconnect plug 1 and carefully...
Wheel speed sensors (ABS sensors) — removal and installation ABS sensors (see illustration 12.0) transmit information about the speed of rotation of the wheels to the engine control unit. Sensors receive information about the number of revolutions of the wheel by induction from...