Table of contents: Front brake pads 🠇 Rear brake pads 🠇
Important! If the removed brake pads can be reinstalled, they should be marked accordingly to ensure installation in the same place. It is also recommended to mark which pad is the inner and which is the outer. Otherwise, the brake pad wear indicator light will not work. In addition, if the old pads are not installed correctly, the front brakes may pull to one side.
1. Partially drain the brake fluid.
Front brake pads
2. Remove cotter pin 1 and unscrew bolt 2 securing caliper 3 (see illustration).
4.2 Remove cotter pin 1 and unscrew bolt 2 securing caliper 3
3. Move the support 3 outward and secure it in this position (see illustration).
4.3 Move the caliper 3 outward
4. Disconnect the brake pad wear sensor plug.
5. Remove the brake pads 4 (see illustration 4.3).
Rear brake pads
6. Unscrew bolts 1 and 2, remove spring 3 (see illustration).
4.6 Unscrew bolts 1 and 2, remove spring 3
7. Disconnect the brake pad wear sensor plug.
8. Remove the brake pads 4 (see illustration).
4.8 Remove the brake pads 4