Repair of car body elements Peugeot 605

Body and interior trim — general description
The body of the Peugeot 605 is made of stamped and welded parts, so serious body repairs should be entrusted to a specialized workshop. The hood, rear and front doors and front fenders are attached with bolts, so they...

Front bumper — removal and installation
1. Jack up the front of the car and place it on jack stands. 2. Open the hood. 3. Disconnect the negative (-) battery terminal from the battery. 4. Press the clamps and remove the pads 1 (see illustration). 2.4 Press...

Rear bumper
See Illustration 2.0. 3.0 Rear Bumper Parts 1 - rear bumper 2 - bumper mounting crossbar 3 - buffer 4 - bumper cover 5, 6, 7 - molding 8 - lid 9 - bracket 10- bracket

Hood — removal and installation
Attention! The hood should be removed together with an assistant. If the old hood is installed, then its adjustment is not required, but before removal, mark the installation position of the hood in order to be guided...

Door — removal and installation
1. Open the door to be removed and secure it to a special support. If there is no support, remove the door together with an assistant, propping it up with a jack, on the rod of which place a wooden block. 2. Unscrew the...

Rear of the center console — removal and installation
1. Press the retaining tabs and remove the mounting compartment 1 under the heater switch panel (see illustration). 6.1 Press the retaining tabs and remove the mounting compartment 1 under the heater switch panel 2....

Glove box — removal and installation
1. Press the clamps and remove the seal 1 (see illustration). 7.1 Press the clamps and remove the seal 1 2. Remove the glove box light bulb holder 2 (see illustration 7.1). 3. Unscrew six bolts 3 (see illustration 7.1)....

Side deflector — removal and installation
1. Press the latches and remove the cover 1 (see illustration). 8.1 Press the latches and remove the cover 1 2. Unscrew bolts 2, and then loosen the fit of the deflector grille 3 using a steel ruler (see arrows A in...

Trunk lid — removal and installation
1. Mark the mounting position of the trunk lid hinge bolt heads by tracing them with a felt-tip pen. This will make subsequent installation of the trunk lid easier. 2. Unscrew the bolts securing the trunk lid hinges and...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Body and interior: Body elements Peugeot 206 (1998-2012)

Link to this section in different formats

TEXTHTMLBB Code