Gasoline engines ZPJ series Peugeot 605

Specification of cars with petrol engines of the ZPJ series
Specification of cars with petrol engines of the ZPJ series

General information
The ZPJ engine and its modification have a V-shaped arrangement of cylinder blocks with two heads and two camshafts, are transversely installed in the engine compartment and are closed with a cover, which, in addition...

Balance shaft drive chain — removal
The balance shaft is mounted on the front cylinder head (see illustration 2.0). 2.0 Balance shaft and its components 1 - balance shaft sprocket mounting bolt 2 - balance shaft sprocket 3 - front balancer 4 - balancing...

Balance Shaft Drive Chain — Installation
Installation of the chain and balance shaft is performed in the reverse order of removal. Attention! When installing sprocket 6 on the camshaft, the reference mark on it must be set opposite the mark on the balance...

Timing chains — removal
Attention! If one of the components of the timing drive is worn out or damaged, it is recommended to replace not only this part, but also to install new chains, sprockets, guides and chain tensioners. To replace the...

Timing Chains — Installation
The timing chains are installed in the reverse order of removal. The threads of the chain guide bolts and tensioner shoes should be lubricated with Loctite. Attention! When laying the chain on the camshaft sprocket of...

Cylinder head — removal
1. Disconnect the negative (-) battery terminal. 2. Front cylinder head. Disconnect the guide tube 1 of the oil dipstick (see illustration). 4.2 Disconnect the guide tube 1 of the oil dipstick 3. Unscrew bolts 2, which...

Cylinder head — installation
46. Install the valves, camshafts, tappets and rocker arm shafts onto the cylinder head. 47. Install stop 45, which limits the axial runout of the camshaft, having lubricated the thread of the stop mounting bolt 44 with...

Power unit — removal and installation
1. Open the hood and place it vertically. 2. Disconnect the terminals from the battery poles. 3. Drain the coolant, see the relevant chapter. 4. Unscrew the mounting bolts and move the power steering pump and power...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

See similar information for other Peugeot models

➨ Power unit: Petrol engines Peugeot 106 (1991-2003)
➨ Power unit: Gasoline engines Peugeot 206 (1998-2012)
➨ Power unit: Gasoline engines Peugeot 305 (1977-1989)
➨ Power unit: Gasoline engines Peugeot 406 (1995-2004)
➨ Power unit: Petrol engines Peugeot 806 (1994-2002)

Link to this section in different formats

TEXTHTMLBB Code