Attention! When installing sprocket 6 on the camshaft, the reference mark on it must be set opposite the mark on the balance shaft sprocket. The tightening torque of the sprocket mounting bolt to the camshaft is 80 Nm. The thread of the camshaft sprocket mounting bolt plug must be lubricated with Loctite before installation.
9. Remove any remaining sealant from the sealing surface A of the cylinder head cover and apply a layer of new sealant (see illustration).
2.9 Remove any remaining sealant from the sealing surface A of the cylinder head cover and apply a layer of new sealant
10. Place the cover on the cylinder head, screw in the mounting bolts by hand, and then tighten them with a force of 10 Nm (see illustration).
Original is contained on the portal [peugeotbook]
2.10 Screw in the cylinder head cover mounting bolts by hand, and then tighten them with a torque of 10 Nm. The illustration shows the cylinder head cover of the ZPJ engine